Tweet  

The first picture shows the driver's side, "Start to remove", position. The visor is down like you would put it, to block the sun from coming in the windshield. Stick the correct size screwdriver into the slot, on the bezel ring, as shown. Rotate the sun visor counterclockwise, towards the driver's side window. When you do this the sun visor's iron shaft will press on the screwdriver shaft. All of these things (visor, screwdriver and slotted bezel ring) will rotate together towards the side window. (You will simultaneously be pushing upwards on the screwdriver to keep the tip of the screwdriver in that little slot on the bezel ring.) After a 1/4 or less turn, the sunvisor will simply drop down, now unattached. See the next picture for this. Now, just separate the wires at the connector. By the way, the connector on my car was sideways up inside the windshield header and I had to "fiddle" with it to get it to come out. Then the electrical connector was hard for me to separate until I realized that there is a little gray plastic retaining clip on the end of the connector that you must remove, (you can see it in the last picture). Everything happens smoothly and without any forcing at all. It is amazing how this opens up the car for taller drivers!

 

Tweet