Autocross/HPDE Tire Trailer For Sale - Indy Area
#1
Burning Brakes
Thread Starter
Member Since: Jan 2005
Location: San Jose CA
Posts: 866
Likes: 0
Received 0 Likes
on
0 Posts
Autocross/HPDE Tire Trailer For Sale - Indy Area
I've got a small harbor freight 48x48 trailer for sale. I used it for hauling my CCWs back and forth to HPDEs. It's got a fairly large lockable plastic storage container bolted to it. Pictures can be found here...
http://www.casadenico.com/gallery/ma...2_itemId=12853
The tires go over the pipes on the front, I used a tie strap to hold them down to the trailer. All lights work fine, wheel bearings were replaced middle of last year, probably have less than 1000 miles on them. Comes with a spare tire for the trailer. There is some minor surface rust on the fenders/frame of the trailer, but works great. Looking for $125 for it picked up on the north side of Indianapolis.
http://www.casadenico.com/gallery/ma...2_itemId=12853
The tires go over the pipes on the front, I used a tie strap to hold them down to the trailer. All lights work fine, wheel bearings were replaced middle of last year, probably have less than 1000 miles on them. Comes with a spare tire for the trailer. There is some minor surface rust on the fenders/frame of the trailer, but works great. Looking for $125 for it picked up on the north side of Indianapolis.
Last edited by tchapma1; 11-18-2007 at 03:20 PM.
#10
Le Mans Master
Darn, too far away and I need to get my hitch installed first.
#13
Burning Brakes
Thread Starter
Member Since: Jan 2005
Location: San Jose CA
Posts: 866
Likes: 0
Received 0 Likes
on
0 Posts
PM box isn't showing full, not sure why it said that. I'll give you a call today Dave, unfortunately I've been out of town since Wed and won't be back until tomorrow, so I doubt we'll be able to meet up.
Thanks
Thanks
#19
I got a question about your setup. I have a similar trailer 4X6, with to chests mounted sideways. They overhang a bit so I have no fenders. I did not carry tires but plan to do so in the future.
I see you mounted two pipes and you said you slide the tires over them.
My question do you slide the tires over the pipe through the center of the wheel thus having to remove the center cap or do you just use one of the openings in the wheels off center? And if you use the side openings don't they slide around?
I see you mounted two pipes and you said you slide the tires over them.
My question do you slide the tires over the pipe through the center of the wheel thus having to remove the center cap or do you just use one of the openings in the wheels off center? And if you use the side openings don't they slide around?