F1 Racing Stage 3 Clutch Kit
#1
Intermediate
Thread Starter
Member Since: Aug 2009
Location: Phoenix Arizona
Posts: 37
Likes: 0
Received 0 Likes
on
0 Posts
F1 Racing Stage 3 Clutch Kit
I am getting ready to replace the clutch in my 2003 C5 and wanted to see if anyone out there has any experience with the F1 Racing Stage 3 Clutch Kit. This kit is supposed to be good for applications up to 550 HP / 547 ft/lbs, and is sold by Gripforce out of California. The kit includes: F1 Racing Heavy-Duty Pressure Plate
* F1 Racing 'MIBA' Copper Ceramic 6-puck Disc (11", 26 spline)
* Release Bearing
* Pilot Bearing
* Slave Cylinder Plate
* Alignment Tool
* Installation Guide
Everything I've read on-line was positive but I wanted to see if anyone had any personal experience with their products. I intend to use this car mainly on track days and do not see my car surpassing the 450-500 HP range. I am considering this application as the cost is approximately $500.
Any input would be appreciated.
* F1 Racing 'MIBA' Copper Ceramic 6-puck Disc (11", 26 spline)
* Release Bearing
* Pilot Bearing
* Slave Cylinder Plate
* Alignment Tool
* Installation Guide
Everything I've read on-line was positive but I wanted to see if anyone had any personal experience with their products. I intend to use this car mainly on track days and do not see my car surpassing the 450-500 HP range. I am considering this application as the cost is approximately $500.
Any input would be appreciated.