Harness for Stock Seats in a C6 Z06
#1
Instructor
Thread Starter
Member Since: Jan 2001
Location: Troutville Virginia USA1
Posts: 2,087
Likes: 0
Received 0 Likes
on
0 Posts
Harness for Stock Seats in a C6 Z06
Has anyone cut holes in their stock seats for the Harness belts? My car is mostly street driven and I don't HPDE enough to invest in race seats. I prefer to keep the stock seats. I have an upholsterer in my area that can cut the seats and finish them to look like a factory job, so he says. Should I ? Anyone else out there had this done?
Last edited by USA1C5; 02-11-2010 at 09:54 PM.
#2
Safety Car
I know everybody will bite my head off, but I've been running the TeamTech JetPilot harness with the stock C6 seats without an issue. Passthroughs would be better, but it works just fine for HPDEs the way I've been doing it. And I'm only 5'7" and it would probably work even better for taller folks.
#3
Melting Slicks
Member Since: Nov 2005
Location: Houston 06 C6 Ysi SC 402 fgd TX
Posts: 2,345
Likes: 0
Received 2 Likes
on
2 Posts
I like you researched the idea.
By the time you pay someone to "do it right" i found you could get a corbeau w seat sliders for less. PM me if you want $$$$ and place to buy new
By the time you pay someone to "do it right" i found you could get a corbeau w seat sliders for less. PM me if you want $$$$ and place to buy new