Anyone have stock pistons out of C5/C6 calipers?
#1
Melting Slicks
Thread Starter
Anyone have stock pistons out of C5/C6 calipers?
Any of you guys do the DRM stainless pistons in the front and still have your stockers floating around?
I need them if you do, I need to do a rebuild on my melted stockers.
I know I need to do the DRM kit. Is the $139 for one side or both sides(4 pistons)?
Please let me know.
Speedadikk(AT)yahoo.com
Thanks.
**EDIT**
Will order the DRM kit today
I need them if you do, I need to do a rebuild on my melted stockers.
I know I need to do the DRM kit. Is the $139 for one side or both sides(4 pistons)?
Please let me know.
Speedadikk(AT)yahoo.com
Thanks.
**EDIT**
Will order the DRM kit today
Last edited by FASTFATBOY; 07-25-2013 at 10:46 AM.
#8
Former Vendor
My wife wanted a hutch for the living room to put my late grandma's china and stuff like that. I told her half would be to showcase car and gun parts
Randy
Randy
#9
Melting Slicks
Thread Starter
Randy, rebuild went well and they are mounted.
What are the orange packets for? I used synthetic high temp grease on the slide pins.
The torque on the banjo bolt said 33ft lbs but my butt puckered up trying to get there, I stopped while I was "ahead".
Will test drive when I get the trans back in the car, waiting on a input shaft.
BTW, they will get a workout installed on this 3800lb barge.
What are the orange packets for? I used synthetic high temp grease on the slide pins.
The torque on the banjo bolt said 33ft lbs but my butt puckered up trying to get there, I stopped while I was "ahead".
Will test drive when I get the trans back in the car, waiting on a input shaft.
BTW, they will get a workout installed on this 3800lb barge.
Last edited by FASTFATBOY; 08-15-2013 at 06:30 PM.