My wiggle test
#1
Racer
Thread Starter
My wiggle test
I posted this in the regular C6Z section, but figured I would post here as well. The car is an 08 and has about 30xxx miles on it, with about six DE's. I got the car with 22000 on it two years ago.
#2
Race Director
I posted this in the regular C6Z section, but figured I would post here as well. The car is an 08 and has about 30xxx miles on it, with about six DE's. I got the car with 22000 on it two years ago.
wiggle test 08 z06 - YouTube
wiggle test 08 z06 - YouTube
#3
Racer
Thread Starter
believe that is a fail.
I think the spec is somewhere around
Stem-to-Guide Clearance – Production – Intake is 0.0010"–0.0024".
Stem-to-Guide Clearance – Production – Exhaust is 0.0010"–0.0026".
I think the spec is somewhere around
Stem-to-Guide Clearance – Production – Intake is 0.0010"–0.0024".
Stem-to-Guide Clearance – Production – Exhaust is 0.0010"–0.0026".
Last edited by jwebsta32; 10-19-2014 at 09:11 PM.
#5
Former Vendor
That is also the spot on the valve with the least amount of wear. The measurement should be taken in the spot where it has the most amount of stem wear. Which is normally in the middle of it's travel.
Randy
Randy