Splitter tunnels
#1
Drifting
Thread Starter
Splitter tunnels
Check out what I made for my undertray.
I set them to 10* so with a bit of body rake they should be right around 12*
Carbon fiber tunnels untrimmed
the one on the left has big flanges to make a mold from it. they wont have that much material when i finish.
I set them to 10* so with a bit of body rake they should be right around 12*
Carbon fiber tunnels untrimmed
the one on the left has big flanges to make a mold from it. they wont have that much material when i finish.
#5
#6
Drifting
Thread Starter
They have. 2006 if I recall correctly, I helped test these parts in the GMAL wind tunnel at the GM tech center.
http://www.acproducts.us/corvetteracebod.htm
http://www.acproducts.us/corvetteracebod.htm
I figure these and the fender vents I had made should help with front end aero
Last edited by 383; 03-21-2017 at 10:14 PM.
#7
Supporting Vendor
I made the first one when I was at LG in 2010- with tunnels to clear the stock radiator support.
http://www.corvetteonline.com/news/n...et-down-force/
http://www.corvetteonline.com/news/n...et-down-force/
__________________
"Keeping You on Track!"
http://www.gspeed.com
877-512-5180
Instagram_Facebook_YouTube
GSpeed C7Z Cooling Development
2014 NASA Texas TT1 Champion
2015 NASA Texas ST1 Champion
2018 NASA TTU & TT3 National Champions
2019 NASA ST2 National Champion
2019 NASA Texas TT2 Champion
2020 SCCA Majors COTA GT2 pole sitter
2020 SCCA Trans Am Road Atlanta SGT Winner
2022 NASA National Champion ST2
2023 NASA National Champion ST2
2023 NASA National Champion TT2
"Keeping You on Track!"
http://www.gspeed.com
877-512-5180
Instagram_Facebook_YouTube
GSpeed C7Z Cooling Development
2014 NASA Texas TT1 Champion
2015 NASA Texas ST1 Champion
2018 NASA TTU & TT3 National Champions
2019 NASA ST2 National Champion
2019 NASA Texas TT2 Champion
2020 SCCA Majors COTA GT2 pole sitter
2020 SCCA Trans Am Road Atlanta SGT Winner
2022 NASA National Champion ST2
2023 NASA National Champion ST2
2023 NASA National Champion TT2
#8
Drifting
Thread Starter
I made the first one when I was at LG in 2010- with tunnels to clear the stock radiator support.
http://www.corvetteonline.com/news/n...et-down-force/
http://www.corvetteonline.com/news/n...et-down-force/
How did you get the ZR1 style splitter on the upper surface? Was it a separate part bonded after cure?
I can tell a ZR1 style splitter on top is about 1.1/2" or 2" bigger than the factory one I love that
Any tips for when I go to make my splitter?