Looking for a 1967 Convertible
#1
Intermediate
Thread Starter
Looking for a 1967 Convertible
Dear folks,
a friend of mine looks for a 1967 small block Convertible in real good condition. It should be a blue car with a 327 small block with 300 or 350 HP. Shifter, no auto, matching numbers not required but a 100 % rust free bird cage as well as perfect frame.
We are settled in germany and pay top price for a great car so if anybody thinks of selling his Convertible currently and has a real good car with above data, please offer, price range between 50.000 and 65.000 dollars.
Thanks Kai
a friend of mine looks for a 1967 small block Convertible in real good condition. It should be a blue car with a 327 small block with 300 or 350 HP. Shifter, no auto, matching numbers not required but a 100 % rust free bird cage as well as perfect frame.
We are settled in germany and pay top price for a great car so if anybody thinks of selling his Convertible currently and has a real good car with above data, please offer, price range between 50.000 and 65.000 dollars.
Thanks Kai
#2
Safety Car
Were you at the Motor World Show in September in Boblingen?
Here is mine, its IN Germany already.
February 17 Built Marina Blue/Bright Blue.
327/300 NOM Corvette with L79 Aluminum Valve Covers.
Frame and Birdcage are SOLID!
Its a Very Solid, Good Looking Car. Turns Heads, ESPECIALLY in Germany.
Radio Works (though its hard to hear over the side pipes)
Originally a Sidepipe Car
In the last two years I have
Rebuilt/Replaced
Diff (3:36)
Trailing Arms, Parking Brake, Half Shafts Restored w /U-joints, New Drive Shaft U-joints
Cross member/Bushings
New Rear Shocks
New Rear Brakes, Pads, Rotors,
New Clutch, Pivot Stud,
Front Brake Pads, Master Cylinder
Water Pump, Starter, Battery,
Wiper Motor Restored (Mike Hicks/Eastern Corvette)
Steering Box Rebuilt (Gary Ramadei), Rebuilt Steering Column (new upper/lower bearings & Turn Signal Switch),
New Dash Harness, Engine Bay Harness, Ballast Resistor, Replaced Dash Bulbs, Upgraded to Euro Headlights with Relay
Restored Seat Frames/Recovered Seats (Al Knock Vinyl, new Foam)
Restored Heater/Box with new Heater Core & Seals, Restored Fresh Air Vent Parts/Seals
Professionally Restored 3367 Holley Carb (Eric at Vintage Muscle Car)
New Visors/Hardware
And probably a few other things that I am forgetting right now.
What is left to do...
I am currently working on the Convertible Top. I am restoring the frame and have the new top with all the weatherstripping.
I also have a set of front Control Arms that are ready to be put on (I blasted em/painted them, replaced bushings & new Ball Joints) the original set is still on the car.
PM me if interested.
A few More...
Won 1st Place at a Car show in August
And here is a Night Shot at the Nuremberg Monthly Car show last year
Here is mine, its IN Germany already.
February 17 Built Marina Blue/Bright Blue.
327/300 NOM Corvette with L79 Aluminum Valve Covers.
Frame and Birdcage are SOLID!
Its a Very Solid, Good Looking Car. Turns Heads, ESPECIALLY in Germany.
Radio Works (though its hard to hear over the side pipes)
Originally a Sidepipe Car
In the last two years I have
Rebuilt/Replaced
Diff (3:36)
Trailing Arms, Parking Brake, Half Shafts Restored w /U-joints, New Drive Shaft U-joints
Cross member/Bushings
New Rear Shocks
New Rear Brakes, Pads, Rotors,
New Clutch, Pivot Stud,
Front Brake Pads, Master Cylinder
Water Pump, Starter, Battery,
Wiper Motor Restored (Mike Hicks/Eastern Corvette)
Steering Box Rebuilt (Gary Ramadei), Rebuilt Steering Column (new upper/lower bearings & Turn Signal Switch),
New Dash Harness, Engine Bay Harness, Ballast Resistor, Replaced Dash Bulbs, Upgraded to Euro Headlights with Relay
Restored Seat Frames/Recovered Seats (Al Knock Vinyl, new Foam)
Restored Heater/Box with new Heater Core & Seals, Restored Fresh Air Vent Parts/Seals
Professionally Restored 3367 Holley Carb (Eric at Vintage Muscle Car)
New Visors/Hardware
And probably a few other things that I am forgetting right now.
What is left to do...
I am currently working on the Convertible Top. I am restoring the frame and have the new top with all the weatherstripping.
I also have a set of front Control Arms that are ready to be put on (I blasted em/painted them, replaced bushings & new Ball Joints) the original set is still on the car.
PM me if interested.
A few More...
Won 1st Place at a Car show in August
And here is a Night Shot at the Nuremberg Monthly Car show last year
Last edited by Revfan; 12-01-2015 at 02:44 AM.
#3
Intermediate
Hallo Revfan.
I´m the friend of Kai and the one, who is looking for the 67 Convertible. Do you have additional fotos, especially from Birdcage and Frame and can you sent them to my emailadress edgar.fiebig@t-online.de including the asking price?
Are you located in Ansbach?
Best regards
Edgar
I´m the friend of Kai and the one, who is looking for the 67 Convertible. Do you have additional fotos, especially from Birdcage and Frame and can you sent them to my emailadress edgar.fiebig@t-online.de including the asking price?
Are you located in Ansbach?
Best regards
Edgar
#4
Safety Car
Just sent some to your e-mail. I'll take some more tomorrow of the undercarriage and anything else you'd like to see.
Just respond to my e-mail and let me know.
Just respond to my e-mail and let me know.
#6
Drifting
Dear folks,
a friend of mine looks for a 1967 small block Convertible in real good condition. It should be a blue car with a 327 small block with 300 or 350 HP. Shifter, no auto, matching numbers not required but a 100 % rust free bird cage as well as perfect frame.
We are settled in germany and pay top price for a great car so if anybody thinks of selling his Convertible currently and has a real good car with above data, please offer, price range between 50.000 and 65.000 dollars.
Thanks Kai
a friend of mine looks for a 1967 small block Convertible in real good condition. It should be a blue car with a 327 small block with 300 or 350 HP. Shifter, no auto, matching numbers not required but a 100 % rust free bird cage as well as perfect frame.
We are settled in germany and pay top price for a great car so if anybody thinks of selling his Convertible currently and has a real good car with above data, please offer, price range between 50.000 and 65.000 dollars.
Thanks Kai
#7
Intermediate
I found a car with a great base and the colour combination I like most, but also a new Corvettefriend.
Greg thank you very much for this great contact and fair deal.
We keep in contact.
My best regards
Edgar
Last edited by maseratimerlin; 02-20-2016 at 05:40 PM.
#10
Pro
67
Google
Forristalls in Houston
67 Marina Blue convertible matching numbers 350 Hp 4 speed
Tank sticker super clean I know the owner.It can be bought in high
50s.I can put you in touch with owner.
Forristalls is a cosigners
Dave
Forristalls in Houston
67 Marina Blue convertible matching numbers 350 Hp 4 speed
Tank sticker super clean I know the owner.It can be bought in high
50s.I can put you in touch with owner.
Forristalls is a cosigners
Dave
#11
Safety Car
#12
Intermediate
That´s what happend in the meantime
Finish
After a lot of bodywork, right now she is painted.
Engine is ready
Frame and everything else is ready to complete the car after the paintjob
Hope she is ready end of Juli.
Best regards
Edgar
Finish
After a lot of bodywork, right now she is painted.
Engine is ready
Frame and everything else is ready to complete the car after the paintjob
Hope she is ready end of Juli.
Best regards
Edgar
The following users liked this post:
maseratimerlin (06-18-2016)