where does this wire connector plug in to
09-11-2009, 10:35 PM
#1
Racer
Thread Starter
where does this wire connector plug in to
I have a dangling ground connector, trying to plug it in somewhere..
It's from the underdash-harness thru firewall, coming out from the harness at same place as double-pink that goes to coil, single black wire is about 6inches, and is grounded. I replaced the harness a few years ago and was like this before too. Is my wiper motor missing a spade? (wiper motor is not working, but case is grounded nonetheless)
manythanks
It's from the underdash-harness thru firewall, coming out from the harness at same place as double-pink that goes to coil, single black wire is about 6inches, and is grounded. I replaced the harness a few years ago and was like this before too. Is my wiper motor missing a spade? (wiper motor is not working, but case is grounded nonetheless)
manythanks
09-12-2009, 01:13 PM
#3
Team Owner
Member Since: Oct 2000
Location: Washington Michigan
Posts: 38,899
Received 1,857 Likes
on
1,100 Posts
Plugs onto the male spade terminal near where the motor wires go into the case. 