Taco Ed

If you have a TPI set up in your C1 did it fit under the hood ? I have seen it but want to make sure before I start the build.

MrPbody

Several on this forum. I know of a 60 here locally, and there will be one (90 L-98) in my 62 in a month or so.
No hood clearance problems at all that I've heard of.

Russ

Taco Ed

Thanks just wanted to recheck and then recheck!! I am talking w/ the tec guys from TPIS and they wanted to make sure. They are helping me do the build so I can build it right.

MrPbody

So are you adding the TPI to an existing engine? or swapping in the complete TPI engine? what ECM do you plan to use, what year TPI?



Russ

Taco Ed

Anyone know if an 700 R4 fits in to the trans tunnel with out any mods or what mods are done?

Taco Ed

I have a TPI from a 90/91 car with everything harness, ECM fuel pump filter injectors etc, that I may put on my 1962 327 block - all I need to do is buy heads and a cam --- HOWEVER I may sell that set up for a few hundred $$ and just add that to a new mini ram TPIS system on the same 327. I have the BW `T10 4 speed by may go to a 700R4

McGivern

My TPI/L31 fit fine under the hood in my '61.

deuce highboy

I have a TPI on my 327 in 1964 coupe. It was on the car when I purchased with a 67 BB hood no problems. Jackie

Injected61

Yes you can get a 700R4 in the trans tunnel with a little modification to the right side. Just a little fiberglass area there the 1-2 piston is on trans. You might not have to if you don't want, but it will almost touch in this area if you don't. I have a 700R4 with 355 TPI ,90 Corvette ECM running in 61 vette.