You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, join Corvetteforum.com today!
Well, to start with I have got a handle on the carpet/seat belt install, and many thanks to the guys who put pictures up and offered advise. I have had to do a lot of cut, trim and adjustment to get it all to fit perfect but it is looking good and I'm about 80% done.
I am now tackling one seat in an effort to understand the resto process for it. I already have the seat rebuild kit from corvette America. I have also viewed the process from CA that another Forum member posted (Thanks) and understand it.
PROBLEM: My 63' seat bottom has all the parts welded in place so I cannot do as CA says and remove the seat adjuster etc. Everything appears to be factory crimped and welded. Is this the way the 63' seat came? I did have what I think was the original foam and burlap in the seat, as the foam was stamped with the GM P/N and "63", plus the burlap had a lot of fine wire throughout the has been corroded away, and the burlap is tied up with twine, not wire as is in the kit.
I'm not sure I have a specific question as yet, I'm still trying to figure out what I am going to do. If someone has any suggestions or comments on what they ran across with their seat rebuild, I am all