IFS identification ?
#2
Team Owner
Member Since: Oct 2000
Location: Washington Michigan
Posts: 38,899
Received 1,857 Likes
on
1,100 Posts
#3
Le Mans Master
It also looks a little bit like the old TCI IFS kit that was sold a number of years ago because their kit was various components needing to be welded separately as opposed to the later one-piece crossmember versions I've seen from Jim Meyer Racing.
Mike T - Prescott AZ
Mike T - Prescott AZ
#4
Advanced
Thread Starter
Thanks for the replies.
I did call 'Fatman' and sent them these photo's. The guy I spoke with
said it wasn't theirs except possibly the crossmember.
I have spent a couple of hours 'googling' under different titles and have not come up with a match.
I do think it is an older version IFS in comparing it to all of the photo's of the most recent products seen online
I may replace my existing frame (rust issues) and this frame is very reasonably priced but am hesitant because of the unknown. I was also planning to add a IFS at some point in the future so this would 'kill 2 birds with 1 stone' so to speak
Thanks
I did call 'Fatman' and sent them these photo's. The guy I spoke with
said it wasn't theirs except possibly the crossmember.
I have spent a couple of hours 'googling' under different titles and have not come up with a match.
I do think it is an older version IFS in comparing it to all of the photo's of the most recent products seen online
I may replace my existing frame (rust issues) and this frame is very reasonably priced but am hesitant because of the unknown. I was also planning to add a IFS at some point in the future so this would 'kill 2 birds with 1 stone' so to speak
Thanks
#5
Le Mans Master
It looks very similar to this Mustang II front end kit offered by Speedway Motors...
http://www.speedwaymotors.com/Mustan...dles,2089.html
Good luck... GUSTO
http://www.speedwaymotors.com/Mustan...dles,2089.html
Good luck... GUSTO