strut rods rear suspension bent?
#1
strut rods rear suspension bent?
i am rebuilding the original rear suspension on my 67. one of the lower strut rods is not perfectly straight. in fact, both of them are no perfectly round in cross section - they look a bit rough - but one of them seems to have a very slight curve/bend to it as i look along its length.
does this mean it is damaged along the way somewhere? or is this just the way it is from the factory?
does this mean it is damaged along the way somewhere? or is this just the way it is from the factory?
#2
Burning Brakes
i am rebuilding the original rear suspension on my 67. one of the lower strut rods is not perfectly straight. in fact, both of them are no perfectly round in cross section - they look a bit rough - but one of them seems to have a very slight curve/bend to it as i look along its length.
does this mean it is damaged along the way somewhere? or is this just the way it is from the factory?
does this mean it is damaged along the way somewhere? or is this just the way it is from the factory?
#4
Race Director
There are a few different ones (replacements) available depending on the vendor. I found the ones from LICS closest to originals. That may or may not matter to the OP.
The ones on my 1967 car were also bent. Possibly from Bubba's hammer or by Bubba lifting the rear by these strut rods.
Larry
The ones on my 1967 car were also bent. Possibly from Bubba's hammer or by Bubba lifting the rear by these strut rods.
Larry
#5
Safety Car