heater/vent dials of 64 illumination
#1
Melting Slicks
Thread Starter
heater/vent dials of 64 illumination
The dial inscriptions are supposed to light-up with the light coming from the bajonet fixed under the clock. The effect is not very convincing...is this normal? I tried filament bulbs and led...
#2
Le Mans Master
yes.
pretty normal.
52 year old technology and design.
It's all the little archaic details like these and many others that make old corvettes (and all old cars for that matter) special.
pretty normal.
52 year old technology and design.
It's all the little archaic details like these and many others that make old corvettes (and all old cars for that matter) special.
#3
Team Owner
Member Since: Feb 2003
Location: Sitting in his Nowhere land Hanover Pa
Posts: 48,985
Received 6,929 Likes
on
4,774 Posts
2015 C2 of Year Finalist
Try new plastic dials
#4
Melting Slicks
Thread Starter
#5
Team Owner
Member Since: Feb 2003
Location: Sitting in his Nowhere land Hanover Pa
Posts: 48,985
Received 6,929 Likes
on
4,774 Posts
2015 C2 of Year Finalist
#6
Melting Slicks
Thread Starter
I cut the top 3/8" of the bajonet, installed a small angle LED to limit sideways spill over of light that may appear from under the dash cluster. Dials look much better, update after sunset
#7
Race Director
YES..I use LED's where the factory lighting design was rather poor at best. And I am NOT worried about 'judging' eyes.
DUB
DUB