WTB fuel pump for 1966 427/425 HP
#2
Advanced
Thread Starter
Member Since: Jun 2004
Location: Orem UT
Posts: 78
Likes: 0
Received 0 Likes
on
0 Posts
Are these rare?
Did other Chevrolet engines use the same fuel pump? The engine has a 1967 pump with a different pump-to-carb line than the reproduction line that I recently received. Now I would like to get the correct pump, in any condition. Thanks.
#3
Drifting
Member Since: Jun 2000
Location: Southern NJ
Posts: 1,596
Received 52 Likes
on
33 Posts
C2 of Year Finalist (stock) 2019
This person sells 100% correct 66 427/425 fuel pumps. I bought one from him. 610-562-3626 10AM-10PM Eastern time please!!!! I dont remember his name. he is in PA. Good Luck John Lolli aka JL66REDCPE
#4
Advanced
Thread Starter
Member Since: Jun 2004
Location: Orem UT
Posts: 78
Likes: 0
Received 0 Likes
on
0 Posts
Dated Components
Thanks for the lead. The owner is Jeff Dotterer, at: datedcomponents.classicjunkyard.com/
He is very knowledgeable and helpful. However, we both decided that there is some missing information in our mutual understanding of the correct early L72 fuel system, pump to Y-block. In other words, the inverted flare pump fitting is not compatible with the 1/4 pipe elbow adapter for sale by multiple vendors.
He is very knowledgeable and helpful. However, we both decided that there is some missing information in our mutual understanding of the correct early L72 fuel system, pump to Y-block. In other words, the inverted flare pump fitting is not compatible with the 1/4 pipe elbow adapter for sale by multiple vendors.
#5
Drifting
66 bb pump
GOAT HILL CLASSICS SELLS THE CORRECT PUMP,CALL5624377664 IHAVE KWOWN HIM FOR YEARS,NICE GUY IF YOUR OLD PUMP IS GM NO 40482 I WOULD BUY IT ,CALL ME I COULD ADD TO THE LINE TO PUMP : SITUATION THAT MIGHT HELP. 66RACER 5054878292
#6
Drifting
Member Since: Jun 2000
Location: Southern NJ
Posts: 1,596
Received 52 Likes
on
33 Posts
C2 of Year Finalist (stock) 2019
66BBCoupe (Peter Martin) purchased one of these fuel pumps for his 66 427/425 car. You may want to send him an email to see how he made out with it. He currently has a thread going on the c1/c2 general discussion forum about a rocker stud letting loose. You can get his email address from there.