Jamess411

Finally pulled the trigger and could not be happier. Nothing makes working on my car more fun to do then not having to lie on the floor any more.
Atlas 10k lift….3000 delivered and installed.

chazde3

Looks great. My dad just HAD to have a lift for the garage. He bought one and had it delivered. It's been sitting outside since it was delivered 15 years ago because he would have had to cut some holes in the ceiling. One day I might get it put in lol.

Jud Chapin

Awesome!

briankeery

Nice, but isn't it gonna be a little tight getting passenger side wheels off? Looks like you had the space to move the lift 3-4 feet off the wall.

Jamess411

There is a good 3 feet between the car and the wall….wanted enough room on the left for another car.

Lupigiato

Big sky in that garage!

LT1driver

looks like a 20 foot ceiling, nice lift and garage.

Bob K

I have about 3' of space between my lift and wall. So far it's been enough room. Your shelving looks pretty beefy.

Your car looks nasty with those big rear meats hanging there. Very nice car and garage!

Bob K.

Jamess411

Love those shelves….had them in a garage in Dallas as well. Same type as Home Depot and Lowe's has. The center cross bars are cut short and re welded to fit.

Gordonm

Wish I had that ceiling height! That is nice. I had my 2 poster against the wall like that due to space limitations like you. Always wish I had more to move the lift over but I made do. Those shelves are killer. Nice setup and any car with wheelie bars is

C3_ERROR

7 foot ceilings suck in my garage.

Just wondering, what rating in the concert floor have to have for a 2 post?

RS69

Very nice and a great price too. I have a 2 post that I bought used and love it.

Flying Low

Very nice

doorgunner

What's with the training wheels on the Vette?!?!"

But seriously.....the lift looks great....the car looks greater.

69small block

I put up a worth made in texas love so much easier to do things

Jamess411

Lol training wheels…..you never know when that little kid in you will come out and push that gas pedal all the way to the floor

persuader

When installing a two post lift. You need a concrete slab no thinner than 4 inches. And the post's have to be at least a minimum of 12 inches from any crack or seam. I have installed a few of these throughout the years . last summer my brother and I had to move our shop and we had to disassemble the bendpak that wew have. Insadently, next saturday

lurch59

There are compressive strength specifications for the concrete also, although most concrete is within spec.

persuader

Yes. 3000 psi minimum.

Jamess411

I wanted to get a Bendpak but they said it was 2 weeks to get one.