WTB: 79 Plenum Valve..(pic)
02-18-2008, 05:16 PM
#1
Advanced
Thread Starter
Member Since: Jan 2005
Location: Richmond TX
Posts: 95
Likes: 0
Received 0 Likes
on
0 Posts
WTB: 79 Plenum Valve..(pic)
Just starting the long journey....
Looking for a Plenum valve for my 79. I was going through the Vaccum system for the AC and found that mine was so briddle if was falling out as I removed it. I'm not looking for the actuator assembly but the plastic door shown in the picture below (#6).
If anyone has one in good condition or can point me in the right direction, I spent an hour or so looking at the usual suspects (Corvette Central, Ecklers, Zip, etc...) with no luck. I also sent a couple emails to vendors with no responses yet. Hope someone can help.
Thanks!
Looking for a Plenum valve for my 79. I was going through the Vaccum system for the AC and found that mine was so briddle if was falling out as I removed it. I'm not looking for the actuator assembly but the plastic door shown in the picture below (#6).
If anyone has one in good condition or can point me in the right direction, I spent an hour or so looking at the usual suspects (Corvette Central, Ecklers, Zip, etc...) with no luck. I also sent a couple emails to vendors with no responses yet. Hope someone can help.
Thanks!
02-19-2008, 07:22 AM
#2
Pro
02-19-2008, 10:42 AM
#3
Race Director
Just starting the long journey....
Looking for a Plenum valve for my 79. I was going through the Vaccum system for the AC and found that mine was so briddle if was falling out as I removed it. I'm not looking for the actuator assembly but the plastic door shown in the picture below (#6).
If anyone has one in good condition or can point me in the right direction, I spent an hour or so looking at the usual suspects (Corvette Central, Ecklers, Zip, etc...) with no luck. I also sent a couple emails to vendors with no responses yet. Hope someone can help.
Thanks!
Looking for a Plenum valve for my 79. I was going through the Vaccum system for the AC and found that mine was so briddle if was falling out as I removed it. I'm not looking for the actuator assembly but the plastic door shown in the picture below (#6).
If anyone has one in good condition or can point me in the right direction, I spent an hour or so looking at the usual suspects (Corvette Central, Ecklers, Zip, etc...) with no luck. I also sent a couple emails to vendors with no responses yet. Hope someone can help.
Thanks!
is this what your looking for?
02-20-2008, 11:34 AM
#4
Advanced
Thread Starter
Member Since: Jan 2005
Location: Richmond TX
Posts: 95
Likes: 0
Received 0 Likes
on
0 Posts
parts..
What does this valve rub against...seems like the ones I keep finding look chewed up on the edges? The actuator actually makes this plastic peice bend to open this door, right?
Thanks for the info ikwhite, and I'll get back with you vettesplus.
Thanks!
Thanks for the info ikwhite, and I'll get back with you vettesplus.
Thanks!
02-20-2008, 01:39 PM
#5
Race Director
its not worn on the edge, i have 2 of them and that is how it is made...ed
