Might Need Frame/Part of Frame
#1
Burning Brakes
Thread Starter
Member Since: Oct 2006
Location: Henrico VA
Posts: 1,044
Likes: 0
Received 0 Likes
on
0 Posts
Might Need Frame/Part of Frame
Hi,
VanSteel said that my frame did not look to good and we might need to weld in certain sections. My car is a '69 and I don't know what the differences are in different years of C3s, but if anyone has a whole or partial frame (preferrably '69 or close to '69), that's what I'm looking for. My build thread is below. Thanks.
http://forums.corvetteforum.com/c3-g...post1582137508
-Adam
VanSteel said that my frame did not look to good and we might need to weld in certain sections. My car is a '69 and I don't know what the differences are in different years of C3s, but if anyone has a whole or partial frame (preferrably '69 or close to '69), that's what I'm looking for. My build thread is below. Thanks.
http://forums.corvetteforum.com/c3-g...post1582137508
-Adam
#3
Team Owner
Member Since: Jun 2000
Location: Southbound
Posts: 38,928
Likes: 0
Received 1,469 Likes
on
1,248 Posts
Cruise-In II Veteran
#4
Former Vendor
I have a very nice late '68 frame that has a Van Steel suspension up-grade installed.
I'll see if I can post the link here.
geopar@gvtc.com
I'll see if I can post the link here.
geopar@gvtc.com
#5
Drifting
I just purchased a rolling chassis and will have my left over frame. It has some sections that are bad, but others are just fine if you need some cut pieces. It's mid 70s but shouldn't matter depending on what you need.