Foil Backed Heat & Sound Deadener Kits On Sale! **149.99**
#1
Former Vendor
Thread Starter
Member Since: Dec 2007
Location: Ft Worth TX
Posts: 22,135
Likes: 0
Received 2 Likes
on
2 Posts
St. Jude Donor '12-'13
Foil Backed Heat & Sound Deadener Kits On Sale! **149.99**
The temperatures are on the rise, your C3 could most likely use some cooling off! Our new kits are CNC machined for perfect fit and coverage.
This 3/8" foil backed material not only reduces inside heat but it also has great sound blocking properties. Excessive road noise will be a thing of the past.
Easy to install, and priced right for forum members!
ON SALE $149.99
CLICK HERE TO ORDER:
http://www.corvettemods.com/1968-198...ld_p_6277.html
This 3/8" foil backed material not only reduces inside heat but it also has great sound blocking properties. Excessive road noise will be a thing of the past.
Easy to install, and priced right for forum members!
ON SALE $149.99
CLICK HERE TO ORDER:
http://www.corvettemods.com/1968-198...ld_p_6277.html
Last edited by corvettemods1; 06-05-2014 at 01:00 PM.
#11
Question. I understand you have foil on both sides. Got it. And you have insulation between the two. Great. Real nice CNC cutouts too. This all being said, insulation could be anything from dirt to fiberglass to shredded toilet paper to fish guts to roofing tar to butyl to rubber to air bubbles to...anyway, you get the idea.
What's yours made of?
Thanks!
What's yours made of?
Thanks!
#12
Did this item change just recently? I purchased this kit on Oct 29th and mine doesn't have foil on both sides, just one. Same item number it appears, which is 6277.
For people asking about fitment, it is absolutely amazing. I figured I'd be glueing it into place, however the fitment was so good I didn't need to. It formed perfectly to the curves and stayed in place while I put the carpet in over it. I did have to trim where the deadner met the rear storage area, however a descent pair of scissors took care of it really easily. Overall it's probably the best fitting aftermarket interior part I've ever seen.
For people asking about fitment, it is absolutely amazing. I figured I'd be glueing it into place, however the fitment was so good I didn't need to. It formed perfectly to the curves and stayed in place while I put the carpet in over it. I did have to trim where the deadner met the rear storage area, however a descent pair of scissors took care of it really easily. Overall it's probably the best fitting aftermarket interior part I've ever seen.
#18
Racer
I actually bought the raw (uncut) form of this and made my own pieces. If I knew I could have got it pre-cut I would have, not hard to cut but let the pro's do it. Anyway it works great for heat. For sound I think it works but I have side pipes so they drown out most noise as it is.