WANTED: 2 mint or very near mint Trim Rings
08-22-2014, 11:52 AM
#41
Hi BC,
I see the same vendor each year at Carlisle (again today) with new rings and caps.
They look very nice from the front. They have 4 clips but are turned 45 degrees. So aren't too good for judging but make a nice appearance.
They're stainless and flash chromed as original. I forget the price but they're quite reasonable.
Would you be interested in those? He seems to price them in sets of 4. But would probably feel just 2.
Let me know…. I'm going back tomorrow, (Friday), and likely Saturday too.
Regards,
Alan
If I come up to the NCRS regional in Marlborough in September can I get a ride in the Donzi?
I see the same vendor each year at Carlisle (again today) with new rings and caps.
They look very nice from the front. They have 4 clips but are turned 45 degrees. So aren't too good for judging but make a nice appearance.
They're stainless and flash chromed as original. I forget the price but they're quite reasonable.
Would you be interested in those? He seems to price them in sets of 4. But would probably feel just 2.
Let me know…. I'm going back tomorrow, (Friday), and likely Saturday too.
Regards,
Alan
If I come up to the NCRS regional in Marlborough in September can I get a ride in the Donzi?
Viz
08-26-2014, 11:50 AM
#42
Melting Slicks
Thread Starter
I will take a look..thanks I really just need one as I found one, but would buy two....the Donzi is in Maine and will be back just outside Boston for storage, if around though you should come check out the Corvette!
Last edited by BOSTONCAMARO; 08-26-2014 at 11:52 AM.
11-14-2014, 08:36 PM
#50
Melting Slicks
Pretty sure I have one, second design (clips correctly oriented to the valve stem, but notches to retain clips rather than spot welds), NOS... $250.
Regards,
Stan Falenski
Regards,
Stan Falenski
11-24-2014, 12:59 PM
#52
Melting Slicks
Thread Starter
I am still looking, really want to find a clean original, rather than repro, even if it is a GM repro
thanks for the posts, still holding out for a good one at a good price
thanks for the posts, still holding out for a good one at a good price
