FS: 68-79 Non A/C Corvette heater housing box cover and blower motor
#1
Racer
Thread Starter
FS: 68-79 Non A/C Corvette heater housing box cover and blower motor
Hi All,
I bought this for a project but can't use it so I figured one of you might need this. It's stamped 3014360 and looks to be in really good shape except for an area on top where it looks like there is extra resin from the fiberglass. I think it was once mounted but I'm not sure. The fan works as well but it's missing one screw that holds it too the cover. I'm asking $100 shipped and paypalled in the CONUS, local northern NJ get's it for $85.
Thanks,
Sam
I bought this for a project but can't use it so I figured one of you might need this. It's stamped 3014360 and looks to be in really good shape except for an area on top where it looks like there is extra resin from the fiberglass. I think it was once mounted but I'm not sure. The fan works as well but it's missing one screw that holds it too the cover. I'm asking $100 shipped and paypalled in the CONUS, local northern NJ get's it for $85.
Thanks,
Sam
#3
Racer
Thread Starter
If your car has a/c this won't fit. Chevy made the hole for the non a/c car smaller. This plate is too short and shallow. Now if you were going to delete the heater ir temp control and know how to lay fiberglass then I guess this could be used.