#14 Weber Aluminum Flywheel Steel insert 168 tooth 14" neutral balance SBC BBC
#1
Race Director
Thread Starter
#14 Weber Aluminum Flywheel Steel insert 168 tooth 14" neutral balance SBC BBC
Here is the Ebay listing. If a forum member wants it Bid on it. If you win let me know and I will refund shipping fees to the brotherhood. MORE PHOTOS ON EBAY AD!
http://www.ebay.com/itm/221699381012?item=221699381012&viewitem=&vxp=mtr
Weber Aluminum Flywheel with the solid steel insert, no holes in face like the new ones. 14" #14 Dual pattern will take 11" or 10.5" clutch. Neutral balance 2 piece rear main bolt pattern.it is in very, very good condition, never machined, don't need it. The pictures don't show it well but you can still see the original machining marks on the plate. The ring gear is perfect, no chips or wear. Machined by Goode. Made in USA. You buy a Fidanza, Centerforce, Spec, American Powertrain, Zoom or McLeod you will have holes in the face where the plate attaches and it is likely not made in USA. New ones start at over $350. This came out of a dragster built in the early 70's that was never 100% completed or raced. It was started and moved around the shop a few times, that is all the use this has seen and is obvious looking at it in person. Some of these were labeled Shaffer but this one still even has the Weber sticker stuck on it from over 40 years ago. Really nice piece. I will start it at $250 with NO RESERVE!. BUY IT NOW GETS FREE SHIPPING! FREE LOCAL PICKUP!
Here is some good reading on the advantages.
http://www.hotrod.com/how-to/engine/...ower-increase/
http://www.ebay.com/itm/221699381012?item=221699381012&viewitem=&vxp=mtr
Weber Aluminum Flywheel with the solid steel insert, no holes in face like the new ones. 14" #14 Dual pattern will take 11" or 10.5" clutch. Neutral balance 2 piece rear main bolt pattern.it is in very, very good condition, never machined, don't need it. The pictures don't show it well but you can still see the original machining marks on the plate. The ring gear is perfect, no chips or wear. Machined by Goode. Made in USA. You buy a Fidanza, Centerforce, Spec, American Powertrain, Zoom or McLeod you will have holes in the face where the plate attaches and it is likely not made in USA. New ones start at over $350. This came out of a dragster built in the early 70's that was never 100% completed or raced. It was started and moved around the shop a few times, that is all the use this has seen and is obvious looking at it in person. Some of these were labeled Shaffer but this one still even has the Weber sticker stuck on it from over 40 years ago. Really nice piece. I will start it at $250 with NO RESERVE!. BUY IT NOW GETS FREE SHIPPING! FREE LOCAL PICKUP!
Here is some good reading on the advantages.
http://www.hotrod.com/how-to/engine/...ower-increase/
Last edited by 63mako; 03-03-2015 at 02:54 AM.