0Full Throttle Corvette

We have a limited number of 70-77 Rocker panels back in stock. These will not last long and once these are gone it will be a few months before they are back in stock.
http://www.fullthrottlecorvette.com/...ir_p_1184.html

Alan 71

Hi FTC,
Are these a new reproduction with the mounting tab near the front or are they the reproductions that have been available in the past?
Regards,
Alan

0Full Throttle Corvette

Alan, these do have the tab on the front.

62corvette

How do they compare with originals? Gauge of material, crispness of stamping, etc?

jhudec

Interesting that these are supposed to have the tab, because if you use the link provided
it does not show the tab. So, as a potential purchaser I would not think these had the tab if you go by what you see on the website it does not mention it at all. Unless I missed something?
Joe

63vette427

I sent a PM to FTC and he is working on posting a picture of them with the tabs. I'm hoping they look nice.

Alan 71

Hi,
This would be pretty terrific if there's finally a more accurate and higher quality reproduction!
Regards,
Alan

0Full Throttle Corvette

Ok folks, here are the only pictures I have of these.

69FASTFUN

The end does not look right here is a picture of an original

13611

Pretty darn close!

redrdstr72

Are these parts anodized?

How do the mounting holes align to the body vs originals? Reproductions to date are terrible.

Thanks.

Revi

FYI -I ordered a set of these rocker panels from Full Throttle Corvette. They arrived today packaged and shipped by Corvette America. I have not opened them yet.

62corvette

Please fill us in. We haven't gotten much response from full throttle.

forman

ok i have been looking for a while for some decent ones ,, I got mine today and they look ok they could have spent a little more buffing and sanding the reveal part of the rocker i wish i could show you what Im talking about but i cant down load any pics right now ,,,,, I will try in a bit

forman

you can see the ripples and where the white haze is where the buffing was done poorly but these things are real real close the last pic shows the haze where its pouris

forman

Well after looking at the second one .. I thinking about sending them back .. A scratch and a ding and the vertical lines are getting to me .. I know they are repros but for me to use them on my car I will have to put 6-7 hours of labor sanding and buffing to get them to my liking

69FASTFUN

Before you send them back do a test fit to see if the fit is at least good!!

forman

they do fit

Alan 71

Hi,
Since this is a Parts For Sale thread I REALLY can't comment.
Regards,
Alan

redrdstr72

Full Throttle has not responded to my earlier post as yet.

Please, can I ask those that have purchased them:
- are they anodized as OE?
- do they fit as well as OE?