Wanted 69 front bumper and grill brackets, parking lamps, marker lights, grills etc
#21
Le Mans Master
Thread Starter
Member Since: Dec 2009
Location: Saskatoon Saskatchewan
Posts: 6,397
Received 640 Likes
on
463 Posts
Hey Priya,
Did you get your bumper bracket set yet?
I received all of what I had ordered so far.
Missing 2 outer rods to complete one set.
Just ordered the other pieces to make 2 full sets of the other brackets and rods.
I found on DocRebuild's site the full bolt set for only $29.95.
Happy hunting......
Dennis
Did you get your bumper bracket set yet?
I received all of what I had ordered so far.
Missing 2 outer rods to complete one set.
Just ordered the other pieces to make 2 full sets of the other brackets and rods.
I found on DocRebuild's site the full bolt set for only $29.95.
Happy hunting......
Dennis
#23
Le Mans Master
Thread Starter
Member Since: Dec 2009
Location: Saskatoon Saskatchewan
Posts: 6,397
Received 640 Likes
on
463 Posts
Hey Priya,
Did you get your bumper bracket set yet?
I received all of what I had ordered so far.
Missing 2 outer rods to complete one set.
Just ordered the other pieces to make 2 full sets of the other brackets and rods.
I found on DocRebuild's site the full bolt set for only $29.95.
Happy hunting......
Dennis
Did you get your bumper bracket set yet?
I received all of what I had ordered so far.
Missing 2 outer rods to complete one set.
Just ordered the other pieces to make 2 full sets of the other brackets and rods.
I found on DocRebuild's site the full bolt set for only $29.95.
Happy hunting......
Dennis
#25
Le Mans Master
Thread Starter
Member Since: Dec 2009
Location: Saskatoon Saskatchewan
Posts: 6,397
Received 640 Likes
on
463 Posts
I have these bumper brackets now:
I still need the little twisted bumper reinforcement brackets that bolt to the above brackets, the 69 bumperette brackets, the nose reinforcement rod that goes to the centre of the front clip, the three 69 grills, grill mouldings, grill brackets, front side marker lights, and parking lamp assemblies
I still need the little twisted bumper reinforcement brackets that bolt to the above brackets, the 69 bumperette brackets, the nose reinforcement rod that goes to the centre of the front clip, the three 69 grills, grill mouldings, grill brackets, front side marker lights, and parking lamp assemblies
#26
vette
Sorry to takes so long. I will be loading up the remaining parts to go to Fla. I see you have received some stuff so I will key on the things you still need. Should know this week end. Just an FYI
RVZIO
RVZIO
The following users liked this post:
Priya (08-15-2016)
#28
Senior Member
Member Since: Jan 2008
Location: Easton, PA
Posts: 12,154
Received 2,031 Likes
on
1,103 Posts
St. Jude Donor '10
PM sent on parts found today at Carlisle Priya.
David
David
#29
Senior Member
Member Since: Jan 2008
Location: Easton, PA
Posts: 12,154
Received 2,031 Likes
on
1,103 Posts
St. Jude Donor '10
B-Man's 69 rear with Priya light fixtures found today and acquired. I have the rear light harness too. Win-Win.
David
Last edited by AllC34Me; 08-25-2016 at 05:23 PM.
The following users liked this post:
Priya (08-26-2016)
#30
Senior Member
Member Since: Jan 2008
Location: Easton, PA
Posts: 12,154
Received 2,031 Likes
on
1,103 Posts
St. Jude Donor '10
Priya.
Interest.
Interest.
#32
Senior Member
Member Since: Jan 2008
Location: Easton, PA
Posts: 12,154
Received 2,031 Likes
on
1,103 Posts
St. Jude Donor '10
Thank you.
#33
Senior Member
Member Since: Jan 2008
Location: Easton, PA
Posts: 12,154
Received 2,031 Likes
on
1,103 Posts
St. Jude Donor '10
Priya, here you go. I spent about two hours this morning removing the four light fixtures from B-man's 69 rear section. All four fixtures came out. One fixture had one bolt break off about 1/3 the way up. I am showing all four of them and a detailed picture of the one with the broken bolt. The good news is there is still enough bolt left to attach to the rear of the car. I put a nut on it to show you that you will have enough to attach this one as well.
I ran a tap on each of the eight bolts and I would recommend you media blast them and run an additional tap on the threads, then use new nuts to hold them in place.
If you want them then I would like to get $50 for the four of them plus actual shipping to you. I won't make any money on them but that is not my goal anyway, my goal is to reduce the overall price to B-Man so maybe I can ship his two parts to him for free.
If you want them I will pack them and get you a shipping cost, you let me know which method you want me to use again this time, e.g. USPS or FedEx.
Let me know if you have any questions.
Best regards,
David
I ran a tap on each of the eight bolts and I would recommend you media blast them and run an additional tap on the threads, then use new nuts to hold them in place.
If you want them then I would like to get $50 for the four of them plus actual shipping to you. I won't make any money on them but that is not my goal anyway, my goal is to reduce the overall price to B-Man so maybe I can ship his two parts to him for free.
If you want them I will pack them and get you a shipping cost, you let me know which method you want me to use again this time, e.g. USPS or FedEx.
Let me know if you have any questions.
Best regards,
David
The following users liked this post:
Priya (08-28-2016)
#34
Le Mans Master
Thread Starter
Member Since: Dec 2009
Location: Saskatoon Saskatchewan
Posts: 6,397
Received 640 Likes
on
463 Posts
Priya, here you go. I spent about two hours this morning removing the four light fixtures from B-man's 69 rear section. All four fixtures came out. One fixture had one bolt break off about 1/3 the way up. I am showing all four of them and a detailed picture of the one with the broken bolt. The good news is there is still enough bolt left to attach to the rear of the car. I put a nut on it to show you that you will have enough to attach this one as well.
I ran a tap on each of the eight bolts and I would recommend you media blast them and run an additional tap on the threads, then use new nuts to hold them in place.
If you want them then I would like to get $50 for the four of them plus actual shipping to you. I won't make any money on them but that is not my goal anyway, my goal is to reduce the overall price to B-Man so maybe I can ship his two parts to him for free.
If you want them I will pack them and get you a shipping cost, you let me know which method you want me to use again this time, e.g. USPS or FedEx.
Let me know if you have any questions.
Best regards,
David
I ran a tap on each of the eight bolts and I would recommend you media blast them and run an additional tap on the threads, then use new nuts to hold them in place.
If you want them then I would like to get $50 for the four of them plus actual shipping to you. I won't make any money on them but that is not my goal anyway, my goal is to reduce the overall price to B-Man so maybe I can ship his two parts to him for free.
If you want them I will pack them and get you a shipping cost, you let me know which method you want me to use again this time, e.g. USPS or FedEx.
Let me know if you have any questions.
Best regards,
David
#35
Senior Member
Member Since: Jan 2008
Location: Easton, PA
Posts: 12,154
Received 2,031 Likes
on
1,103 Posts
St. Jude Donor '10
#36
Senior Member
Member Since: Jan 2008
Location: Easton, PA
Posts: 12,154
Received 2,031 Likes
on
1,103 Posts
St. Jude Donor '10
On their way to you Priya.
The following users liked this post:
Priya (08-29-2016)
#38
Senior Member
Member Since: Jan 2008
Location: Easton, PA
Posts: 12,154
Received 2,031 Likes
on
1,103 Posts
St. Jude Donor '10
Good morning Priya, I hope this finds you doing well and the weather is Summer like for you.
If possible you might want to update your first post in this thread to show what you have already acquired and what you still may need. I am glad to help you search further but would have to try and figure out what you now have and still need. Let us all know and we will step up the search.
David
If possible you might want to update your first post in this thread to show what you have already acquired and what you still may need. I am glad to help you search further but would have to try and figure out what you now have and still need. Let us all know and we will step up the search.
David
#40
Former Vendor
Converting my 79 to chrome bumpers. Looking for the following:
1) The left and right hockey stick shaped grill moldings (no broken studs)---have both; $50.00 for the pair
2) The driver's side (left) grill and centre grill---have both; $65.00 for the pair
3) Complete grill bracket set---sorry
4) The two bumperette to frame crossmember brackets, #3469/3470 L&R in the first picture--have both; $10.00 for the pair
5) The two small twisted bumper corner reinforcement brackets #11009K in the first picture---have both; $15.00 for the pair
6) the long nose reinforcement/support rod shown by the yellow arrow in the second picture--have it; $15.00
7) the two 69 parking lamp assemblies and lenses
8) rear license plate light assembly--have both; 45.00 for the pair
9) two 69 side marker light assemblies including bezels, retainers (and nuts if you have them)---have them all with all assembly pieces; $60.00 for all
10) 68-73 rear tail light panel letters "T" and "E"; have them; $free with purchase of afore items
11) two "Stingray" fender emblems--have them; $35.00 for the pair
12) eight 69 side fender louvre "gill" trim pieces--have these; $180.00 for the set of eight (4 left and 4 right)
13) the two fender corner mouldings that go at the base of the windshield--have them; 70.00 for the pair
Shipping is extra---do u have a US drop box?
1) The left and right hockey stick shaped grill moldings (no broken studs)---have both; $50.00 for the pair
2) The driver's side (left) grill and centre grill---have both; $65.00 for the pair
3) Complete grill bracket set---sorry
4) The two bumperette to frame crossmember brackets, #3469/3470 L&R in the first picture--have both; $10.00 for the pair
5) The two small twisted bumper corner reinforcement brackets #11009K in the first picture---have both; $15.00 for the pair
6) the long nose reinforcement/support rod shown by the yellow arrow in the second picture--have it; $15.00
7) the two 69 parking lamp assemblies and lenses
8) rear license plate light assembly--have both; 45.00 for the pair
9) two 69 side marker light assemblies including bezels, retainers (and nuts if you have them)---have them all with all assembly pieces; $60.00 for all
10) 68-73 rear tail light panel letters "T" and "E"; have them; $free with purchase of afore items
11) two "Stingray" fender emblems--have them; $35.00 for the pair
12) eight 69 side fender louvre "gill" trim pieces--have these; $180.00 for the set of eight (4 left and 4 right)
13) the two fender corner mouldings that go at the base of the windshield--have them; 70.00 for the pair
Shipping is extra---do u have a US drop box?
George
210-748-4693
geopar@gvtc.com
Last edited by Corvettes by George; 06-13-2017 at 01:21 PM.