*** WTB - 1968 Corvette 1/2 shaft ***
#1
Safety Car
Thread Starter
*** WTB - 1968 Corvette 1/2 shaft ***
Hello all,
Looking to buy an OEM Corvette half shaft for a '68 Vette. 2-1/2" diameter. Must be a clean damage free example. No dents, gouges or pits.
Thanks in advance.
Looking to buy an OEM Corvette half shaft for a '68 Vette. 2-1/2" diameter. Must be a clean damage free example. No dents, gouges or pits.
Thanks in advance.
#3
Safety Car
Thread Starter
Hello George,
Hope all is well with you.
Really only need one - but if you have a matched pair that are in mint condition - I would consider buying both.
Purchased one online earlier this month - beautiful condition - arrived 3" diameter - arrrrrghh.
Last edited by bkvette3; 11-05-2016 at 11:23 AM.
#7
Safety Car
Thread Starter
Hello Grant
Thanks for replying to my wanted to buy ad - much appreciated.
I am usually all over NOS parts - but this time around - I just want a good clean OEM used 1/2 shaft. To match the other side.
Thanks for replying to my wanted to buy ad - much appreciated.
I am usually all over NOS parts - but this time around - I just want a good clean OEM used 1/2 shaft. To match the other side.
Last edited by bkvette3; 11-07-2016 at 06:35 PM.
#8
Grant
#15
Safety Car
Thread Starter
I understand - we are all busy in our lives.
If you have a real nice one (damage free, no rust, dents or pits) with the flange - that would be great. I would change the u-joint anyways. Again - the nicest one you have.
Also - would you happen to have an OEM '68 rear deck (convertible) driver's side latch (GM 3942775). The spring broke on mine - top won't latch.
Let me know - thanks in advance.
Blair K.
Last edited by bkvette3; 11-15-2016 at 08:22 PM.