parting out 69 big block frame
#2
Intermediate
holley carb
PRICE REDUCED. I NEED THE ROOM.
PARTING OUT THE ENTIRE CHASSIS FROM MY 69 427 - 435 COUPE
If you want the entire chassis,;
1969 427 - 435 corvette rolling chassis. Includes front and rear suspension, trailing arms, brakes, brake lines, fuel line, F41 springs and front and rear sway bar, positraction differential, half shafts, a-arms, steering. It is a 4 speed chassis. The chassis can roll, as it sits on 4 Cragar SS wheels and 4 tires that hold air. Cragars are fair, 3 tires need replacement.
PRICE OF $1,150.00 IS THE VALUE OF THE CORES AT DUNTOV MOTORSPORTS
You will need to replace all rubber bushings, as they are all worn. You will also need to REPAIR AT LEAST ONE RUSTY SPOT, THEN sand and repaint the chassis.
NO Steering column, no drive shaft, no fuel tank.
The frame has at least one rusty spot on the passenger side, forward of the trailing arm mount. You will need to buy a 23" "end cap" replacement (cost about $125.00). There may be other bad spots, but I have not seen any other bad spots. Refurbish this one then put your body on top.
IF YOU ONLY NEED CERTAIN PARTS;
1. TRAILING ARMS, COMPLETE WITH HUBS $225.00 EACH.
2. BIG U-JOINT AXLE SHAFTS $25.00 EACH
3. F-40 7 LEAF REAR SPRING AND FRONT COILS, $100.00/SET
4. FRONT & REAR SWAY BARS, $150/SET
5. UPPER CONTROL ARMS $25.00 EACH
6. LOWER CONTROL ARMS $40.00 EACH
7. FRONT SPINDLE $100 EACH
8. POWER STEERING CYLINDER, DRAG LINK, PUMP & BRACKETS FOR EITHER SMALL OR BIG BLOCK $250.00 (EVERYTHING YOU NEED TO CONVERT TO POWER STEERING)
9. POSITRACTION REAR, COMPLETE (3.50 OR 3.70, DON'T REMEMBER) $500.00
10. BARE FRAME. $500.00
11. 4 cragar ss wheels with tires ( 2 15 x 8, 2 15 x 7) 2 tires fair, 1 tire new, 1 tire holds air $150.00. Cragars are in fair condition. some pitting, some chrome flaking/
ALSO AVAILABLE is the CAN AM front clip. Price for the front clip with the chassis is an additional $150.00
IF ALL YOU NEED IS THE FRAME, NO SUSPENSION, STEERING, OR BRAKES, CONTACT ME, AND I WILL MAKE YOU A SUPER DEAL.
Things I could take for partial or full trade are:
Small cap- tach drive HEI distributor
working TI tach drive distributor
New black carpet set for 69 coupe
American Racing "Daisy" wheels, 15 x 10 and/or 15 x 8
Milodon or Moroso road race type (SIDE SUMP) oil pan (big block)
FRONT NOSE WHERE HEADLIGHTS MOUNT FOR 69.
69 Rear exhaust panel / valence
Holley 850 carb
FiTech or Holley Sniper or PowerJection EFI kit.
tri-power air cleaner assembly
30 gallon, 150 psi Air compressor
PARTING OUT THE ENTIRE CHASSIS FROM MY 69 427 - 435 COUPE
If you want the entire chassis,;
1969 427 - 435 corvette rolling chassis. Includes front and rear suspension, trailing arms, brakes, brake lines, fuel line, F41 springs and front and rear sway bar, positraction differential, half shafts, a-arms, steering. It is a 4 speed chassis. The chassis can roll, as it sits on 4 Cragar SS wheels and 4 tires that hold air. Cragars are fair, 3 tires need replacement.
PRICE OF $1,150.00 IS THE VALUE OF THE CORES AT DUNTOV MOTORSPORTS
You will need to replace all rubber bushings, as they are all worn. You will also need to REPAIR AT LEAST ONE RUSTY SPOT, THEN sand and repaint the chassis.
NO Steering column, no drive shaft, no fuel tank.
The frame has at least one rusty spot on the passenger side, forward of the trailing arm mount. You will need to buy a 23" "end cap" replacement (cost about $125.00). There may be other bad spots, but I have not seen any other bad spots. Refurbish this one then put your body on top.
IF YOU ONLY NEED CERTAIN PARTS;
1. TRAILING ARMS, COMPLETE WITH HUBS $225.00 EACH.
2. BIG U-JOINT AXLE SHAFTS $25.00 EACH
3. F-40 7 LEAF REAR SPRING AND FRONT COILS, $100.00/SET
4. FRONT & REAR SWAY BARS, $150/SET
5. UPPER CONTROL ARMS $25.00 EACH
6. LOWER CONTROL ARMS $40.00 EACH
7. FRONT SPINDLE $100 EACH
8. POWER STEERING CYLINDER, DRAG LINK, PUMP & BRACKETS FOR EITHER SMALL OR BIG BLOCK $250.00 (EVERYTHING YOU NEED TO CONVERT TO POWER STEERING)
9. POSITRACTION REAR, COMPLETE (3.50 OR 3.70, DON'T REMEMBER) $500.00
10. BARE FRAME. $500.00
11. 4 cragar ss wheels with tires ( 2 15 x 8, 2 15 x 7) 2 tires fair, 1 tire new, 1 tire holds air $150.00. Cragars are in fair condition. some pitting, some chrome flaking/
ALSO AVAILABLE is the CAN AM front clip. Price for the front clip with the chassis is an additional $150.00
IF ALL YOU NEED IS THE FRAME, NO SUSPENSION, STEERING, OR BRAKES, CONTACT ME, AND I WILL MAKE YOU A SUPER DEAL.
Things I could take for partial or full trade are:
Small cap- tach drive HEI distributor
working TI tach drive distributor
New black carpet set for 69 coupe
American Racing "Daisy" wheels, 15 x 10 and/or 15 x 8
Milodon or Moroso road race type (SIDE SUMP) oil pan (big block)
FRONT NOSE WHERE HEADLIGHTS MOUNT FOR 69.
69 Rear exhaust panel / valence
Holley 850 carb
FiTech or Holley Sniper or PowerJection EFI kit.
tri-power air cleaner assembly
30 gallon, 150 psi Air compressor