Crane Valve train parts (Springs/push-rods, etc) for sale-NIB
#1
Drifting
Thread Starter
Member Since: Oct 2000
Location: Harrison Township, Mi
Posts: 1,526
Received 0 Likes
on
0 Posts
Crane Valve train parts (Springs/push-rods, etc) for sale-NIB
I have the parts I purchased to go w/my Crane Powermax hydraulic roller (.509/.528 and 222/230 @.05"). The engine builder felt the springs weren't quite stiff enough and the push rods were too short (these were bought in a kit, with the cam). These parts have not been used (one cylinder was mocked up) and are still in the box.
#2
Drifting
Thread Starter
Member Since: Oct 2000
Location: Harrison Township, Mi
Posts: 1,526
Received 0 Likes
on
0 Posts
Re: Crane Valve train parts (Springs/push-rods, etc) for sale-NIB (randy72)
I left out price...Not sure what I want for them. Original price for kit was roughly $700..Not looking for anywhere near that. Would be willing to negotiate a trade for 72 vette or 66 mustang parts. These parts are for a sbc.
Vette parts needed-saddle tan console, seat belts saddle tan, a pillar trim in saddle tan or would trade for labor to re-bond my sagging pass. side fender
Mustang parts needed-Holley carb for 66 K-code 289, RH Fastback 1/4 panel, RH k-code manifold, 8,000 RPM shelby dash tach, all wiring, gt350 rear 1/4 windows...pretty much everything
Vette parts needed-saddle tan console, seat belts saddle tan, a pillar trim in saddle tan or would trade for labor to re-bond my sagging pass. side fender
Mustang parts needed-Holley carb for 66 K-code 289, RH Fastback 1/4 panel, RH k-code manifold, 8,000 RPM shelby dash tach, all wiring, gt350 rear 1/4 windows...pretty much everything