bruced267

Anyone have any advice on how to remove it without breaking the fitting that goes into the firewall? I have new muffler hose so Im not worried about the bottom fitting. I do have to salvage to the fitting that goes into the firewall!!

hosspowerinc

HEAT!! I used a small propane torch. Maybe a little WD-40 too. My .02

bruced267

I tried PB blaster, I need some smaller tools, I cant get the big open end wrench on the fitting straight! Maybe Ill try some hack tools?

hosspowerinc

I think I might have sacrificed a wrench to the tool gods. Go buy a cheap set from big lots and then you dont have to worry about destroying them.

bruced267

That was my next move!! A friend already has a bunch of cut up tools!!