TPI intake ducting
#1
Racer
Thread Starter
Member Since: Jul 2008
Location: Gippsland, VIC Australia
Posts: 258
Likes: 0
Received 1 Like
on
1 Post
TPI intake ducting
I've had a TPIS miniram setup on my '80 for a while now with a slinky hose duckting to the air filter mounted in front of the air con.
Has anyone got or know of a better setup.
I'm thinking about cutting a hole beside the radiator to get the air filter in front of the radiator.
or runnuing through the origanal ducting over the radiator & into an airbox / filter.
fyi, the clutch fan is gone, I'm running a couple thermo's
Has anyone got or know of a better setup.
I'm thinking about cutting a hole beside the radiator to get the air filter in front of the radiator.
or runnuing through the origanal ducting over the radiator & into an airbox / filter.
fyi, the clutch fan is gone, I'm running a couple thermo's
#7
Le Mans Master
I run a air filter in front of the rad by notching the top of the rad shroud and shorting the hood prop to restrict the opening. The filter sits about 4 inches above the oil cooler so it don't get too much water splash.
The air feed is 4 inch diameter tubing that is flattened oval where it goes over the rad. I don't have FI but this should work the same as my carb system cold air feed.
The air feed is 4 inch diameter tubing that is flattened oval where it goes over the rad. I don't have FI but this should work the same as my carb system cold air feed.