Wiper override switch wires.
#1
Racer
Thread Starter
Wiper override switch wires.
I'm in the process of wiring up the dash, console on my 69 project. I have installed the wiper override switch and according to the diagram a "red" & "red/white" wire terminate at the switch. I have attached a photo of the switch and wires. Is this correct? Could someone post a photo of their working switch & wiring. I will try & get another shot of mine. Thanks.
[IMG][/IMG]
[IMG][/IMG]
Last edited by Zoix; 01-07-2014 at 12:02 PM. Reason: more information.
#2
Team Owner
Member Since: Sep 2006
Location: Westminster Maryland
Posts: 30,173
Likes: 0
Received 2,878 Likes
on
2,515 Posts
#3
Burning Brakes
You have it correct Richard. The 69 switch had the terminals parallel to the floor and had two separate wires (red and red/white) going to them. 70 and later had the terminals perpendicular to the floor and had the same two wires, but in a single harness like what Alan shows.
Ed
Ed
Last edited by restoman1; 01-07-2014 at 02:14 PM.
#4
Racer
Thread Starter
#5
Team Owner
Member Since: Sep 2006
Location: Westminster Maryland
Posts: 30,173
Likes: 0
Received 2,878 Likes
on
2,515 Posts
Hi Z,
Looks like a pretty serious 69 in your pictures!
12 years well spent.... just think how much trouble you could have gotten in to with out a good project to take you energy!
Regards,
Alan
Looks like a pretty serious 69 in your pictures!
12 years well spent.... just think how much trouble you could have gotten in to with out a good project to take you energy!
Regards,
Alan