One more 68 wiper question
#1
Melting Slicks
Thread Starter
One more 68 wiper question
Trying to figure out how to wire up the windshield wiper squirter, got the 2 tabs on the squirter pump in the Corvette, see that, and looking at the 68 wiring schematic, I see maybe 2 bullet looking connectors dead ending nearing the wiper motor. So, likely that is it?? I suppose there was not room on the schematic to print in "wiper squirter"? Also, following the schematic, the 2 bullet connectors do go back to the wiper switch. Confirmation or clarification would be appreciated, thanks.
#2
Former Vendor
Member Since: Aug 2006
Location: Jeffersonville Indiana 812-288-7103
Posts: 76,656
Received 1,813 Likes
on
1,458 Posts
St. Jude Donor '08-'09-'10-'11-'12-'13-'14-'15
The Yellow and Dark Blue wires operate the washer pump. They will have little bullet connectors on the ends. This is 69 but the bullet terminals can be seen on the jumper harness at the top right of the two wires shown.
Willcox
Willcox
#4
Former Vendor
Member Since: Aug 2006
Location: Jeffersonville Indiana 812-288-7103
Posts: 76,656
Received 1,813 Likes
on
1,458 Posts
St. Jude Donor '08-'09-'10-'11-'12-'13-'14-'15
My pleasure..
Willcox
Willcox