Torque spec for upper ball joint
02-26-2016, 08:15 PM
#1
Melting Slicks
Thread Starter
Torque spec for upper ball joint
Since the AIM shows rivets for the upper ball joints rather than nut and bolt, what should I torque them too? I am using a G8 bolt with a lock washer and nut. TIA Andy
02-26-2016, 08:38 PM
#2
Race Director
Member Since: Apr 2011
Location: North of Toronto - Ontario
Posts: 10,853
Received 3,138 Likes
on
2,069 Posts
My Moog ones gave the following for those three bolts
1/4" dia - 10-12 ft-lb
5/16 Dia - 14-19 ft-lbs
3/8 dia - 28-45 ft lbs
HIH
M
1/4" dia - 10-12 ft-lb
5/16 Dia - 14-19 ft-lbs
3/8 dia - 28-45 ft lbs
HIH
M
The following 2 users liked this post by Mooser:
Andy Tuttle (02-27-2016),
Rbrt (03-24-2021)