Wiper door actuator shaft gasket question
#1
Racer
Thread Starter
Member Since: Aug 2001
Location: Raleigh NC
Posts: 473
Likes: 0
Received 0 Likes
on
0 Posts
Wiper door actuator shaft gasket question
I recently replaced the gasket/sleave that slides over the shaft to the wiper door actuator. Now that gasket is pulling through the back of the actuator as the shaft slides in and out, causing a vacuum loss.
Is this an adjustment issue? Do I have the thing slid too far up the shaft or something?
Any ideas?
Is this an adjustment issue? Do I have the thing slid too far up the shaft or something?
Any ideas?