Marty Brown Racing & Machine......any experience?
02-20-2008, 05:06 PM
#1
Safety Car
Thread Starter
Marty Brown Racing & Machine......any experience?
I know this should probably be in a regional forum, but this one gets a lot more traffic...
Does anyone have any experience dealing with Marty Brown Racing & Machine, in Glen Burnie, MD?
I'm having a high idle problem, and a call to Tony's Corvette Shop brought up the possibility of my throttle plates binding on the TB, since I remember there being some side-to-side play when I took it off for cleaning. So, I need to have the holes drilled out and press-fit bushings inserted. A call to several machine shops in the local area turned up this one as the most promising, but I figured I'd see if anyone had dealt with them before. They quoted me about $80 for the job, which seems reasonable in my book. The alternative is buying a 52mm TB online, which is looking like about $300.
Does anyone have any experience dealing with Marty Brown Racing & Machine, in Glen Burnie, MD?
I'm having a high idle problem, and a call to Tony's Corvette Shop brought up the possibility of my throttle plates binding on the TB, since I remember there being some side-to-side play when I took it off for cleaning. So, I need to have the holes drilled out and press-fit bushings inserted. A call to several machine shops in the local area turned up this one as the most promising, but I figured I'd see if anyone had dealt with them before. They quoted me about $80 for the job, which seems reasonable in my book. The alternative is buying a 52mm TB online, which is looking like about $300.
