Nokones

My custom dash panel is coming along. It should be done by next week.

armysnipe

Finished mounting LTCC coils on heads..

MSGT-R

Holly Crap!!
Okay, my driver is now officially a "dog".

96LT1AUTO

Brake Trans Safety Interlock was stuck in Park so I apply some heat from a blow dryer to the Solenoid and it started working so I greased up plunger took it out of garage warmed her up and got a little sideways

helphos

It's always nice to see someone using imagination and ingenuity to solve a problem. Congratulations on fixing it without a trip to the parts counter!

kael

Re-mounted intake manifold and finished re-attaching exhaust manifolds. Wrapped bottom of EGR tube, goodbye nasty silver thing!

A four day Iowan weekend with 60+ degrees in February? That's just not nice Mother Nature. At least I had the garage door open most of the day.

Lanaue

Put a new blower motor in

divotdug

Have an '84 with the Z51 suspension. Just realized after almost a year of ownership that the driver's side wheels were on the wrong ends of the car. Perfect day to jack it up and swap the wheels.

Mike Kamholz

Replaces the oil sender unit and valve cover gaskets. On the 88. Here is to no more leaks

jdlclam

Put on a polish and drove for a couple of hours. Can't miss the opportunity when it's 60 and sunny in February.

Gibbles

Nice sunday drive, breaking in a new torque converter and transmission pump.
i also tweaked the 3-4 clutch while it was apart, so that's wearing in as well...

​​​​​​​

SmokinBlack

Looking good.

1993C4LT1

CLEAN

SmokinBlack

Your '84 sounds great. Thanks for sharing.

Gibbles

Thanks man!

It's been an adventure getting this thing running the way i wanted.
it's an absolute joy to drive now, and i don't need a radio at all.

If you notice, I'm working hard to not spin the tires at take off (even though i really want to).
​​​

SmokinBlack

Welcome. I'm almost finished with the '87 I've been working on all winter. I have a few more weeks of work and I can't wait for it to be ready. I haven't even given thought to the exhaust yet. But, I love the way yours sounds.

Gibbles

I love the sound, nice lightly cammed idle, the almost exotic tone higher in the rpm (xpipes).

Exhaust system is from melrose.
long tube headers, 3in pipes, and i had them send me a second xpipe.
mufflers are flowmaster 40's

hcbph

Actually it was saturday, I finished putting on the Banski suspension upgrade on my 86 and took it out for a short run - love it. Next is getting the alignment done then tires to go along with the Reproduction C6 Z06 rims that I found with the correct backspacing on them.

Then it's time to do a little driving and enjoy it for a while.

xrav22

A bit close this time but didn't do anything but warm it up and drive it over. I think the ol Corvette deserves a tune up now.

armysnipe

Got ARH headers mocked up around my Champ road race oil pan. They don't touch. I'm going to add 1/8" spacers to gain a little more clearance.