FS: Elgin Cam, lifters, pushrods & roller tips
#1
Racer
Thread Starter
FS: Elgin Cam, lifters, pushrods & roller tips
Everything was installed by the builder. But it was the wrong parts. Engine was only started there to make sure it had good oil pressure. Other than that everything is new.
Thsi would be great if you have a small block that just needs a refresher. Or something to slap together if you are selling it or have a beater car.
Elgin E860S camshaft..pretty small profile. 269/276 .404 .415
Elgin lifters & pushrods
1.5 roller tip rockers.
Just trying to recoup some cash, because of having to order new parts.
1st reasonable takes it.
Can take pics if nessessary. Prety much boxed up & ready to ship out of here.
Thsi would be great if you have a small block that just needs a refresher. Or something to slap together if you are selling it or have a beater car.
Elgin E860S camshaft..pretty small profile. 269/276 .404 .415
Elgin lifters & pushrods
1.5 roller tip rockers.
Just trying to recoup some cash, because of having to order new parts.
1st reasonable takes it.
Can take pics if nessessary. Prety much boxed up & ready to ship out of here.
#2
Racer
Thread Starter
Also have a pair of Spectre Valve covers. Never installed.
Make a reasonable offer( as with all this suff). I just dont want to throw this stuff away. I dont have room for it to lay around.
Here are the valves covers I have.
http://www.jegs.com/cgi-bin/ncommerc...03&prmenbr=361
Make a reasonable offer( as with all this suff). I just dont want to throw this stuff away. I dont have room for it to lay around.
Here are the valves covers I have.
http://www.jegs.com/cgi-bin/ncommerc...03&prmenbr=361