Polished Billet Center Bolt Valve Covers, 1.6 roller rockers w/ locks, push rods
10-20-2011, 03:00 PM
#1
Pro
Thread Starter
Member Since: Jan 2002
Location: Some where, I'm still looking. Texas
Posts: 657
Likes: 0
Received 1 Like
on
1 Post
Polished Billet Center Bolt Valve Covers, 1.6 roller rockers w/ locks, push rods
Polished Center Bolt Valve Covers that have been clearanced to fit an LT1, LT4 and will also fit on an L98 motor.
Take all of the above for $350 plus shipping and paypal fee.
Located in the North Dallas area.
Take all of the above for $350 plus shipping and paypal fee.
Located in the North Dallas area.
Last edited by Da-Cajun; 09-19-2014 at 07:04 PM.
09-17-2014, 02:34 AM
#5
Pro
Thread Starter
Member Since: Jan 2002
Location: Some where, I'm still looking. Texas
Posts: 657
Likes: 0
Received 1 Like
on
1 Post
BTW, these are Crane roller rockers and all these parts have idle time only. Started building the L98 then decided to pull it and go with an LS motor. The rockers alone were right at the $250 I'm asking for all of the above.
09-19-2014, 06:35 PM
#6
Pro
Thread Starter
Member Since: Jan 2002
Location: Some where, I'm still looking. Texas
Posts: 657
Likes: 0
Received 1 Like
on
1 Post
Wow!!!! It would appear the market for SBC parts have pretty much dried up to nothing....I had a brand new Dart Lil M 434 with all forged internal rotating parts along with heads and solid roller shaft rocker system that I sold last year. I now thinking that was the right move for sure....
Anyways, if any of you remaining SBC guys are in need of these parts do let me know....
Anyways, if any of you remaining SBC guys are in need of these parts do let me know....
12-09-2014, 09:45 PM
#11
Pro
Thread Starter
Member Since: Jan 2002
Location: Some where, I'm still looking. Texas
Posts: 657
Likes: 0
Received 1 Like
on
1 Post
I do appreciate the heads up for sure.....With Christmas just around the corner it can be a tough sellers market. But then again, tax returns will be coming around just as well. It's what it is I suppose. I no longer have any use for these so they need to go to someone who can put them to good use....Again, thanks for the heads up!!!
