1996 LT-1 Part out
#1
Le Mans Master
Thread Starter
1996 LT-1 Part out
ALL THAT'S LEFT. Car has been scraped.
Power seat tracks: $125 pair shipped, $75 each shipped
Drivers power seat controler: $45 shipped
Center console arm rest: $80 shipped
Red Floor Matts: $40 shipped
Driver Info Center: $75 shipped
(2) A/C programmers (under dash): $200 shipped ea.
Drivers side headlight assembly: $80 shipped (needs paint)
Stock radiator: $80 shipped
Red Silicone Radiator Hoses and clamps: SOLD
Fiberglass top: SOLD
Gill panels: SOLD
Custom mesh license plate fill panel: SOLD
D36 complete rear end: Van Steel HD u-joints, heim toe bars, poly camber bars, fresh poly batwing bushings & poly control arm bushings (less than 3,000 miles), hawk HP+ pads, Van Steel lower coilover mounts seized onto knuckles, high speed 2.59 gear. $500 + shipping
Hood: $100 (local pick up only, Largo, FL)
Fog lights: $80 shipped, one has small crack. Can have professionally tinted at extra cost.
Rear side marker lights: $50 shipped (pair)
Custom C-beam plates: SOLD
I think I have some other misc parts and pieces laying around I'll add soon.
Power seat tracks: $125 pair shipped, $75 each shipped
Drivers power seat controler: $45 shipped
Center console arm rest: $80 shipped
Red Floor Matts: $40 shipped
Driver Info Center: $75 shipped
(2) A/C programmers (under dash): $200 shipped ea.
Drivers side headlight assembly: $80 shipped (needs paint)
Stock radiator: $80 shipped
Red Silicone Radiator Hoses and clamps: SOLD
Fiberglass top: SOLD
Gill panels: SOLD
Custom mesh license plate fill panel: SOLD
D36 complete rear end: Van Steel HD u-joints, heim toe bars, poly camber bars, fresh poly batwing bushings & poly control arm bushings (less than 3,000 miles), hawk HP+ pads, Van Steel lower coilover mounts seized onto knuckles, high speed 2.59 gear. $500 + shipping
Hood: $100 (local pick up only, Largo, FL)
Fog lights: $80 shipped, one has small crack. Can have professionally tinted at extra cost.
Rear side marker lights: $50 shipped (pair)
Custom C-beam plates: SOLD
I think I have some other misc parts and pieces laying around I'll add soon.
Last edited by shakedown067; 10-30-2016 at 02:52 PM.
#3
Le Mans Master
Thread Starter
I have thrown most everything into a bag. I'll see what I can gather up this afternoon. Will probably be $10 by the time I gather everthing and get them shipped.
#4
#7
#8
Instructor
also interested in the targa if its the tinted version and the screws (6) that hold the air dam up to the nose. thanx joel
Last edited by joeljet; 08-15-2016 at 04:53 PM.
#9
Le Mans Master
Thread Starter
Targa is fiberglass, and has an old vinyl wrap on it.
$200 plus shipping
Side gills, $60 shipped for the pair
Only have the front VBP 32mm sway bar. Rear is gone but might be able to get a stock one if needed. $100 plus shipping for VBP swaybar. $50 for stock rear if I can still get one, plus shipping.
$200 plus shipping
Side gills, $60 shipped for the pair
Only have the front VBP 32mm sway bar. Rear is gone but might be able to get a stock one if needed. $100 plus shipping for VBP swaybar. $50 for stock rear if I can still get one, plus shipping.
#11
Le Mans Master
Thread Starter
OReilly's shows them as different part numbers. I'm surprised though. Probably changed the hose connections.
#12
Safety Car
I am curious as to if you would separate the throttle body, and if so, how much ? I do realize it might be better to be sold with the engine as a whole.
#13
Le Mans Master
Thread Starter
The throttle body is $950, comes with a free motor. Yeah, I doubt I'll part out the motor. I'll let you know if I do though.
The following users liked this post:
shakedown067 (08-17-2016)
#16
Le Mans Master
Thread Starter
#18
Tech Contributor
#20
Le Mans Master
Thread Starter