FS: 92 zr-1 trans zf6 speed w/ black tags
#1
92 zr-1 trans zf6 speed w/ black tags
I'm Selling a 92 ZR1 ZF6 speed with black tags, dual mass flywheel and pressure plate for $2000 OBO + shipping or if your in driving distance I'm in western MA.
#3
OP - I mentioned in a previous thread that the flywheel for sure wasn't ZR-1/LT5 and that the spec on the trans actually might ID it as an '89 L98 build. The missing bulge at the top of the clutch housing for starter drive is further visible that the package isn't ZR-1/LT5.
Since you're selling/offering as a package I'd think you could do better with the sale if you measure/confirm the OD of the "input guide tube" and measure/confirm the ID of the release bearing.
Since you're selling/offering as a package I'd think you could do better with the sale if you measure/confirm the OD of the "input guide tube" and measure/confirm the ID of the release bearing.
#4
...
OP - I mentioned in a previous thread that the flywheel for sure wasn't ZR-1/LT5 and that the spec on the trans actually might ID it as an '89 L98 build. The missing bulge at the top of the clutch housing for starter drive is further visible that the package isn't ZR-1/LT5.
Since you're selling/offering as a package I'd think you could do better with the sale if you measure/confirm the OD of the "input guide tube" and measure/confirm the ID of the release bearing.
Since you're selling/offering as a package I'd think you could do better with the sale if you measure/confirm the OD of the "input guide tube" and measure/confirm the ID of the release bearing.
THAT IS AN ALUMINUM BELLHOUSING, BUT DEAD GIVE AWAY NOT LT5/ZR1 SETUP.
GLWS
#5
I bought the zf to retro fit with a lq4 into my iroc. I was too ambitious and didn't realize how much fabing it takes to fit it in the tunnel. The person I bought it from cut a piece of the bell for a starter. I was told it had 55k on it and it came from a 92 zr1
Last edited by Rich_Holl; 03-29-2017 at 10:26 PM.