Need Help Understanding OBDII info
#1
Safety Car
Thread Starter
Need Help Understanding OBDII info
Ok, I am just wondering how to read this information... I know most of it but have a few questions...
What exactly is the calculated load value?
What is the short term fuel trim and long term fuel trim bank?
What should the ignition timing advanced be at idle, wot, etc?
How do you read the O2 sensor readings and what do they mean? What are the "good" range of values and how can you tell if something is wrong?
I tried to read up on some of this stuff but I think it would be good to get some feedback and info from you guys!
Thanks guys!
What exactly is the calculated load value?
What is the short term fuel trim and long term fuel trim bank?
What should the ignition timing advanced be at idle, wot, etc?
How do you read the O2 sensor readings and what do they mean? What are the "good" range of values and how can you tell if something is wrong?
I tried to read up on some of this stuff but I think it would be good to get some feedback and info from you guys!
Thanks guys!
#2
http://www.cartechbooks.com/vstore/s...=3657&CATID=21
What ever is programmed in to the the PCM.Need tuning software to read program
If working correctly and in CL then the O2 voltage should rapidly change from hi - lo - hi.
If the reading is static then O2 sensor is not working
What ever is programmed in to the the PCM.Need tuning software to read program
If the reading is static then O2 sensor is not working
Last edited by vetteoz; 11-23-2010 at 07:45 AM.
#3
Safety Car
Thread Starter
http://www.cartechbooks.com/vstore/s...=3657&CATID=21
What ever is programmed in to the the PCM.Need tuning software to read program
If working correctly and in CL then the O2 voltage should rapidly change from hi - lo - hi.
If the reading is static then O2 sensor is not working
What ever is programmed in to the the PCM.Need tuning software to read program
If working correctly and in CL then the O2 voltage should rapidly change from hi - lo - hi.
If the reading is static then O2 sensor is not working