MT2500 Service Ride Control light
07-15-2015, 08:43 PM
#1
Burning Brakes
Thread Starter
MT2500 Service Ride Control light
How can I get this scanner to perform the scanning and clearing of codes?
I am using this setup of cartridges below.
I also have the power plug and OBD-1 connector in the car as well.
I am using this setup of cartridges below.
I also have the power plug and OBD-1 connector in the car as well.
07-15-2015, 10:47 PM
#2
Advanced
It has been 15 years or so since I used the cartridges that you have, but I do not remember them being able to do the ride control on GM vehicles. I remember it was able to run air ride test on Ford's. Do you have the manuals that come with the cartridges? They have a lot of information about what the software can do.
07-16-2015, 10:21 AM
#3
Burning Brakes
Thread Starter
It has been 15 years or so since I used the cartridges that you have, but I do not remember them being able to do the ride control on GM vehicles. I remember it was able to run air ride test on Ford's. Do you have the manuals that come with the cartridges? They have a lot of information about what the software can do.
