ZF6 swap... wiring backup lights
#1
Team Owner
Thread Starter
Member Since: May 2002
Location: San Diego , CA Double Yellow DirtBags 1985..Z51..6-speed
Posts: 24,337
Likes: 0
Received 17 Likes
on
16 Posts
ZF6 swap... wiring backup lights
I wasn't really paying any attention to this when installing mine. There's a reverse gear switch somewhere on the trans or shifter that I need to wire up for my reverse lights to work.
Where is it? I have one connnector on the side of the trans, I assume is for the skipshift. I don't remember what else is there.
Anyone got pics of the ZF?
Where is it? I have one connnector on the side of the trans, I assume is for the skipshift. I don't remember what else is there.
Anyone got pics of the ZF?
#2
B/U switch
High and forward of the skip shift solenoid. Very near the top and forward very close to the top left mounting flange to bellhousing. The solenoid has a pigtail and connector. The B/U switch doesn't. I do have a "good" pic. Drop your email addy to me in a PM. I'm not at the computer that has your email information.
-Dave
-Dave
#4
Pics
Your pics should be there! I've got a couple new ZF's for the L98, LT1 and LT4's. I've got a couple for the LT5's but I might just hang on to them.
-Dave
-Dave
#5
Red
Are you sure yours is bad? It's on the pricey side. Do it while it's on the ground! It's tough in the car. There is a K/M tool. I recall ZF Doc "used" to do a loan. I heard I believe it wasn't returned so maybe that's not a possible anymore.
B/U switch is the "red" dot!
B/U switch is the "red" dot!