do they make a O2 sensor emulator??
#1
Instructor
Thread Starter
Member Since: May 2005
Location: Glendale AZ
Posts: 106
Likes: 0
Received 0 Likes
on
0 Posts
do they make a O2 sensor emulator??
do they make a O2 sensor emulator??I have 3 O2 sensors and 2 are used with the headers..any suggestions for the 3rd?? thx's hk
#2
You may want to check out these other threads concerning this.
http://forums.corvetteforum.com/show....php?t=1523613
http://forums.corvetteforum.com/show....php?t=1523611
Hopefully you find the answer you're looking for in these threads.
http://forums.corvetteforum.com/show....php?t=1523613
http://forums.corvetteforum.com/show....php?t=1523611
Hopefully you find the answer you're looking for in these threads.
#6
Racer
Member Since: May 2003
Location: beaverton oregon
Posts: 304
Likes: 0
Received 0 Likes
on
0 Posts
I just left the old one hooked up and tied it out of the way. no codes or issues
I understand the third one doesn't do anything.
you don't need to need an emulator, save your money.
cheers
I understand the third one doesn't do anything.
you don't need to need an emulator, save your money.
cheers
#7
Large Impressive Member
Member Since: Jul 2003
Location: Good health is merely the slowest possible rate at which one can die
Posts: 65,789
Received 68 Likes
on
34 Posts
St. Jude Donor '04-'05-'06-'07
I'm not sure about a '94 but on my '95, I eliminated the 3rd O2 w/o consequence. No simulator is needed for that year.
#9
Drifting
On OBDII, the 2nd sensor behind the cats is to check the efficiency of the cats, and you have to simulate them if removed to keep the SES off.
On the OBDI, the single sensor usually doesn't cause any problems if removed.
On the OBDI, the single sensor usually doesn't cause any problems if removed.