Timken vs. AC Delco
#21
Melting Slicks
Thread Starter
After researching bearings on this forum, I went with HP tapered rear bearings from Wheel Bearings Inc. I replaced both with around 7,000 miles on them after one failed. The HP ones cost a lot more, but should hold up better than my last ones.
My front bearings were tight when I got the car and still seem OK.
113,000 miles. Not sure if they are original or not.
My front bearings were tight when I got the car and still seem OK.
113,000 miles. Not sure if they are original or not.