How much vacuum for egr port on throttle body?
#1
Pro
Thread Starter
Member Since: Feb 2004
Location: San Antonio Texas
Posts: 594
Likes: 0
Received 0 Likes
on
0 Posts
How much vacuum for egr port on throttle body?
How much vacuum should there be at the port on the bottom of the throttle body. When I pull the line off and stick my finger over it there doesn't seem to be any. I just cleaned the throttle body, did i put something back together wrong. Car is a 1990 L98. thanks
#2
Pro
Member Since: Apr 2000
Location: San Diego, Ca USA
Posts: 616
Likes: 0
Received 0 Likes
on
0 Posts
Re: How much vacuum for egr port on throttle body? (90 Convertible)
Dont confuse vacuum with flow. When the volume to be evavuated is small, it doesnt take much actual flow to reach max vac. I am not say you have adequate flow. Put a vac gauge on it and see how long it takes to reach max. Hook asyringe to it and see how long it takes to retract the plunger.
#3
Re: How much vacuum for egr port on throttle body? (TRWSD90)
Did you try reving the engine a little? That may be a ported vacuum that needs the butter flys open a little to show vacuum. If so your vacuum will vary