Part # for ALDL connector
#1
Le Mans Master
Thread Starter
Part # for ALDL connector
I couldn't find this on the KW parts CD. The wires to my connector are fine, but the connector itself doesn't hold the wires in very well. If you push a scan connector over the ALDL, it will push the wires back a bit. I have to press the wires in while hooking up a scan connector to get a good connection.
The ALDL itself seems to have two grey inserts in the back that hold the wires in. These have a lot of play which allow the wires to move back (but not fall out). So I just figured a new one might resolve this easily. But I don't know the part numbers.
The ALDL itself seems to have two grey inserts in the back that hold the wires in. These have a lot of play which allow the wires to move back (but not fall out). So I just figured a new one might resolve this easily. But I don't know the part numbers.
#2
Melting Slicks
I doubt this is a corvette or ZR-1 specific part...it is likely used in alot of GM vehicle. I looked in my parts book but couldn't find it, might be part of the harness.