who does the best head work for the lt5
02-18-2007, 06:31 PM
#1
Racer
Thread Starter
Member Since: Nov 2006
Location: las vegas nev
Posts: 301
Likes: 0
Received 0 Likes
on
0 Posts
who does the best head work for the lt5
I have to replace my head gaskets so I thought I might get the heads ported valve job and new springs. WHO do you guys feel does the best work? thanx for any help
02-18-2007, 07:30 PM
#2
Burning Brakes
Member Since: Feb 2005
Location: Thornton,Co. Press 1 to Proceed in English or 2 for Deportation ...don't let the fence hit you in the azz!
Posts: 766
Likes: 0
Received 0 Likes
on
0 Posts
02-18-2007, 08:05 PM
#3
Drifting
Member Since: May 2005
Location: It's 5 o'clock somewhere
Posts: 1,383
Likes: 0
Received 2 Likes
on
2 Posts
Mark Haibeck
Corey Henderson
south georgia corvettes
jeffvette..and locobob..also do porting..and you can
get your engine powder coated..depends..
if you are gonna take the parts off and mail them..
or..drive there...Ron hansleman is from vegas too,
you might speak to him...hope this helps
02-18-2007, 10:51 PM
#4
Burning Brakes
Member Since: Feb 2005
Location: Thornton,Co. Press 1 to Proceed in English or 2 for Deportation ...don't let the fence hit you in the azz!
Posts: 766
Likes: 0
Received 0 Likes
on
0 Posts
These guys port Lt5 heads???
02-19-2007, 07:19 AM
#6
Le Mans Master
don't forget about mike ebert EHS he has a cnc program setup and gets some pretty spectacular flow numbers.
his "econo stroker" 396 was pulling well over 500 rwhp with stock cams. better than my full boogie LPE LSV 390.
not bad at all!!
his "econo stroker" 396 was pulling well over 500 rwhp with stock cams. better than my full boogie LPE LSV 390.
not bad at all!!
02-19-2007, 09:05 AM
#8
Melting Slicks
02-19-2007, 09:47 AM
#9
Safety Car
Member Since: Apr 2000
Location: Texas, GOOD OLE USA
Posts: 4,643
Received 0 Likes
on
0 Posts
