hiznhrz

Any chance anyone has one?

Thanks.

kmillar

Not sure if an L98 flywheel DM will fit, if so I have 2.
#1) 30,000 miles
#2) 40,000 miles

VetteMed

L98 will NOT fit. LT5 has 8 bolts, L98 has 6.

I have a used LT5 DM flywheel, but it's got over 100K on it.

SORCDRIVER

I have one that I replaced with an aluminum Fidanza. Send me a private message with an offer if you are interested.

Joe Shown
Stapleton, NE

Bans25

I have two.. a brand new on and a second out of a low mile wreck.. I will look up exact miles.

Goldcylon

Nope it will not fit.

hihok9

I have one as well in Western Mass.

Zrxmax

I have either a new one or a low mile one. It has been 3 years since I shuffled flywheels around. PM me if your still looking and I will dig it out.

hiznhrz

My first choice would be new. PM's sent. Thanks for the help.

Luweegy

I'v got the flywheel cutch and preasure plate coming out soon 4k miles on flywheel,clutch is brand new as is preasure plate.Under 100 miles.I'm looking for the light setup rt now.

hiznhrz

I just received a new DM flywheel and pressure plate. The pressure plate came from Carolina Clutch and has 6 bolts to the flywheel. The flywheel I bought from a club member and also has 6 bolts to mate the flywheel to the pressure plate. In an earlier post above VetteMed said the LT-5 DM flywheel is supposed to have 8 bots and a L98 DM flywheel only has 6.

Can anyone tell me if I have the wrong parts?

cv67

6 PP bolts 8 crank bolts (unless 1s for a dowel pin on the crank cant remember)

VetteMed

8 bolts plus 1 pin on LT5.

Zrxmax

Look at the enclosed cardboard box the flywheel was inside of. It has the part number on it. Check and see if the part number is also on the flywheel. I don't have that number recorded here but somebody here on the forum should be able to tell you if it is the correct part number. Or, you should be able to look it up and confirm.

I am looking at my camera phone picture and it looks like the number is... #10124481 I am not positive on that number because it is hard to see in the picture I have.

Glad to hear you recieved the flywheel. Was their any damage to the wooden crate? Is the flywheel in perfect new condition as stated?

LT5corsa

Damn Scott...

Wish you filled out your profile or signed your name on this post!

Pretty sure Jim has a spare flywheel FYI

Do you need a T/O bearing only or the flywheel/clutch/T/O?



David

cv67

This is what it should look like

hiznhrz

Thanks cuisinartvette!

Luweegy

I've got one with 4k miles on it.

HammerZR1

Ebay - Jim Butler Chevrolet $650 new

kennedy5150

Do you still have dual mass flywheel??
I need one for an 1995 LT1 manual transmission.