F/S 89 Conv. Professionally Built Drivetrain. Dart 385, 370 rwh
08-02-2015, 11:55 AM
#1
6th Gear
Thread Starter
Member Since: Aug 2015
Posts: 6
Likes: 0
Received 0 Likes
on
0 Posts
F/S 89 Conv. Professionally Built Drivetrain. Dart 385, 370 rwh
I have my 1989 Corvette Conv up for sale. I work for Corvette Conspricacy out of Celeveland , Oh. that built this car for a customer. I traded for it two years ago.
Custom Drive train and Suspension with less than 7,000 miles Professionally Built by Corvette Conspiracy of Cleveland, Ohio
Built 385 Stroker sbc, Dart Block and Dart 200 Heads. Scat forged crank, Eagle rods, J &E Pistons, Comp Cam & Roller Valve Train, Edelbrock Victor Jr E Intake.
Engine Controlled on LS1 Computer, Custom Optically Triggered Ignition, Coil On Plug, 90mm Billet LS Throttle Body. Custom metal fabbed Air intake and K&N filter. DeWitt’s Alum. Radiator w/ Cooler, Custom Aux Trans Cooler & Engine Oil Cooler. All New Engine Accessories, i.e. Alt, Starter, Water pump,
A/C Compressor (Blows Ice Cold) & Heater Core
Custom Exhaust - Melrose Long tube Headers into fabbed 3” dual stainless steel pipes w/ crossover. Flowmaster mufflers and Metal fabbed Exhaust Tips
Extensively Tuned for reliability & drivability, Gets 24 to 26 MPG hwy. Dyno tuned to 370 rwh.
700r4 Overdrive Auto Trans and Convertor built by Gear Star
Upgraded Diff to 3.55 Gears
Complete Polyurethane Suspension Bushings Front & Rear, Lowered
New Hub Bearings, Hawk Brake Pads, Slotted Rotors & 4 Bilstein Shocks
Aftermarket Grand Sport Wheels – Kumho Ecsta Xs Tires
17 X 9.5 - 285/ 40 R17 front 17 X 11 - 335/ 35 R17 rear
Factory Color Matched Hardtop w/ Defogger and New Black Soft Top
New Leather Seats, New Steering Wheel, Sony CD Player w/ MP3 jack, Etc.
Over $40,000 Invested Asking $16,500
Over $40,000 Invested Asking $16,500
08-08-2015, 10:15 PM
#5
Burning Brakes
GLWSIs your cam trigger an AEM Engine Position Module or is that someone else's? I'm in the middle of a 24x swap and am looking for Cam PS options if I have issues with the timing cover sensor that I'm installing.
08-12-2015, 07:21 PM
#6
6th Gear
Thread Starter
Member Since: Aug 2015
Posts: 6
Likes: 0
Received 0 Likes
on
0 Posts
Sorry for the delay, I've been crazy busy. The Pickup was developed by John the owner of Corvette Conspiracy in Cleveland, Oh. If you have any questions about it or the conversion email him : John@corvetteconspiracy.com. Best Regards, James
