Another AZ C5 Z06 For Sale
#1
Melting Slicks
Thread Starter
Member Since: May 2007
Location: Peoria Arizona
Posts: 2,652
Likes: 0
Received 0 Likes
on
0 Posts
St. Jude Donor '11
Another AZ C5 Z06 For Sale
2003 Z06 550 rwhp on 100 shot and 451rwhp on motor!
This car started as a normal c5 z06 18 months ago. Now it is as follows:
New paint 3 months old!
new brake duct vents front and rear
new corvette emblems
5% limo tint
C6 z06 replica rims brand new
Nitto 555 drag radials in rear
Blackout kit
z06 exhaust plate
Shorty antenna
Interior:
flawless!!
C6z06 shifter
z06 floor mats
Car partition and tray
New radio bezel complete
Apillar dual gauge pod
Nitrous gauge
Wide band gauge
Fuel gauge
Nitrous switchs in ash tray area along with fuel pressure gauge
no tears or rips anywhere
Drivetrain:
Rpm lv5 tranny (3000miles)
Rpm lv3 diff 3.73 gears (0 miles)
Dte brace
Harden output shafts right and left
Textrilia oz700 z grip clutch (3000 miles)
GM performance drilled and slotted rotors (1000 miles)
Napa Gold Ceramic pads
Engine
Custom Grind Cam 232/238 112lsa 119 centerline .600 .600
New oil pump (6000 miles)
New lifters (6000 miles)
AFR 205 62 cc heads (1000 miles)
Fast90 ported
LS2 TB
LG pro long tube headers and high flow cats
Billet oil catch can
painted black fast 90 and valve covers
HSW Nitrous sytem with 10lb bottle and heater and micro edge controller
Halltech Cold air intake
34# injectors
Racetronix upgraded fuel system
new harland sharp rockers
new push rods oem
new timing chain ls2
new slave cylinder for clutch
02 sensors (6000 miles)
B&B PRT Catback
Sorry if i missed anything but this car is a beast and streetable for long cruises! Ask Drewstein we go on long hauls!
The Nitrous has only had two bottle fills and had 5 runs on dyno and 3-4 runs on the track. We just installed the heads and the motor is top notch and all cylinders are at proper compression as if motor were new. Oil changer every 3000 miles or after any track visit.
I have over $20,000 in mods into this car!
$29,000.00
This car started as a normal c5 z06 18 months ago. Now it is as follows:
New paint 3 months old!
new brake duct vents front and rear
new corvette emblems
5% limo tint
C6 z06 replica rims brand new
Nitto 555 drag radials in rear
Blackout kit
z06 exhaust plate
Shorty antenna
Interior:
flawless!!
C6z06 shifter
z06 floor mats
Car partition and tray
New radio bezel complete
Apillar dual gauge pod
Nitrous gauge
Wide band gauge
Fuel gauge
Nitrous switchs in ash tray area along with fuel pressure gauge
no tears or rips anywhere
Drivetrain:
Rpm lv5 tranny (3000miles)
Rpm lv3 diff 3.73 gears (0 miles)
Dte brace
Harden output shafts right and left
Textrilia oz700 z grip clutch (3000 miles)
GM performance drilled and slotted rotors (1000 miles)
Napa Gold Ceramic pads
Engine
Custom Grind Cam 232/238 112lsa 119 centerline .600 .600
New oil pump (6000 miles)
New lifters (6000 miles)
AFR 205 62 cc heads (1000 miles)
Fast90 ported
LS2 TB
LG pro long tube headers and high flow cats
Billet oil catch can
painted black fast 90 and valve covers
HSW Nitrous sytem with 10lb bottle and heater and micro edge controller
Halltech Cold air intake
34# injectors
Racetronix upgraded fuel system
new harland sharp rockers
new push rods oem
new timing chain ls2
new slave cylinder for clutch
02 sensors (6000 miles)
B&B PRT Catback
Sorry if i missed anything but this car is a beast and streetable for long cruises! Ask Drewstein we go on long hauls!
The Nitrous has only had two bottle fills and had 5 runs on dyno and 3-4 runs on the track. We just installed the heads and the motor is top notch and all cylinders are at proper compression as if motor were new. Oil changer every 3000 miles or after any track visit.
I have over $20,000 in mods into this car!
$29,000.00
Last edited by azZ06Mike; 07-03-2009 at 10:31 AM. Reason: Added cam specs
#5
Sent PM's also what size cam does it have and it says oem pushrods, is that correct? Could ya get some more shots of the cars paint outside sunlight and pics of the interior, when you get the time. What's the mileage? Thanks
Last edited by fast droptop; 07-02-2009 at 10:55 PM.